SailNet Community - Reply to Topic
Thread: overhead zippers Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
08-30-2012 12:34 PM
Re: overhead zippers

I have the same issue on my 31. Rather than trying to install a new slider, I have been thinking about simply installing a thin teak batten on top of the zipper to hold everything in place.

Al Lorman
s/v Ann West, PSC 31 No. 55
08-30-2012 12:12 PM
don sanford
Re: overhead zippers

Ed and Bill, Thanks to both of you. I am going down to the boat today to take a very close look at the zipper. If it is in better condition than I thought I like the idea of replacing the slider. If not I might have to try the needle and thread.

Don Sanford
08-30-2012 09:59 AM
Re: overhead zippers

The sliders on my overhead coil zippers corroded to white powder and fell apart when I tried to open them. I picked out the remains of the sliders and removed the last of the white stuff by leaving a vinegar soaked cotton ball against the white stuff for a few hours. I pressed some modeling clay against the zipper and took the impression to an upholstery shop where I bought a few new sliders. After freeing the ends of the zippers from under the gimp at the aft end of the cabin, I opened the zipper up and put on the new sliders. When the gimp was back in place it was all done.

The zippers work well now except for the spot where the original slider died. There the coil is distorted and the slider will not easily pass the spot. A little candle wax, chapstick, or Sailrite's Zipper Lube makes zippers run easier.

Bill Murdoch
1988 PSC 34
Irish Eyes
08-29-2012 08:56 PM
Re: overhead zippers

Had a similar experience on the 31. Sliced open the frozen zipper with a rigging knife( very carefully), fixed the stuff behind the headliner then used my sail repair kit to stich the zipper with needle and thread.

Looks OK and is a lot cheaper than replacing the headliner.
08-29-2012 05:12 PM
don sanford
overhead zippers

Hi Everyone,

I have a 1988 PS34 with a three part vinyl overhead in the saloon. The parts are joined by two for and aft zippers which are so corroded that if unzipped they tend to disintegrate. I partially unzipped one and I cannot zip it shut. It now droops and threatens to furher unzip. I suppose I could replace the entire overhead (complicated and expensive) but I have no idea what other PS boats have for an overhead other than vinyl. If anyone encountered this problem I would very much appreciate your suggstions. Thanks very much

Don Sanford,
S/V Blue Jacket

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome