Ok i will give that a try. Thanks. There is no screws that i can see.
01-16-2013 08:02 AM
Re: out island cutlas bearing (how to remove)
My 1974 OI 28 had one or two set screws. Brass (to better match the outer sleeve of the bearing), placed laterally. Pan-head screws, so the heads were on the surface of the glass. I don't recall whether there was a threaded insert embedded in the fiberglass.
At any rate, if you've removed all paint and the can't find a screw, it may simply not be there (backed out & lost, or never installed). Getting the bearing itself out required a slide hammer. I made one myself out of 3/8" threaded rod, some carefully sized washers & nuts, and a footlong piece of 1/2" galvanized pipe to which I welded a 3- or 4-pound blacksmith's hammer.
It made a lot more racket--and took a lot more force--than I liked.
01-15-2013 06:08 PM
out island cutlas bearing (how to remove)
I have a 1976 morgan out island 37. I have my shaft out and there was some play so i figured it wad a good time to change the cutlass bearing. Cant find set screws that hold it in though. I scraped paint off and think i am down to gell coat but no screws. Anyone familiar with how to remove and install a new one?