SailNet Community - Search Results
Advanced Search
Showing results 1 to 8 of 8
Search took 0.02 seconds.
Search: Posts Made By: Rewards
Forum: Diesel   06-17-2010
Replies: 7
Views: 1,438
Posted By Rewards
Oil level ok, charging at 14v. Hoping it is a...

Oil level ok, charging at 14v. Hoping it is a bad sensor; think I will change out pressure sensor if I can find it. Also replace oil with synthetic; read testimony from race car driver that his...
Forum: Diesel   06-17-2010
Replies: 9
Views: 4,106
Posted By Rewards
If bolts are still tight, i would replace belt,...

If bolts are still tight, i would replace belt, might be stretching.
Forum: Diesel   06-17-2010
Replies: 7
Views: 1,438
Posted By Rewards
Warning horn chirping

Here is a new one: my boat is powered by Yanmar 3GM30F. Motored hard (3400 rpm) for three hours, when pulling up to mooring the warning/starting horn started to chirp ever so slightly until motor...
Forum: Electrical Systems   05-01-2010
Replies: 2
Views: 1,292
Posted By Rewards
Depth transducer test ?

I installed a new Raymarine ST60 depth instrument; must the boat be in the water for the transducer to operate correctly?
Forum: Seamanship Articles   03-30-2010
Replies: 14
Views: 21,759
Posted By Rewards
chaffing

any worry about the tacker chaffing the furled sail? or maybe snap a block at the tacker set low then cleat the tackline for easing the luff.
Forum: Seamanship Articles   03-30-2010
Replies: 14
Views: 21,759
Posted By Rewards
chaffing

My tackline exerts serious pressure on my bow pulpit, what do you think about the "tacker" that wraps around the furled fore sail?
Forum: Gear & Maintenance   03-20-2010
Replies: 4
Views: 786
Posted By Rewards
Thanks for the suggestions, I will let you know...

Thanks for the suggestions, I will let you know results.
Forum: Gear & Maintenance   03-20-2010
Replies: 4
Views: 786
Posted By Rewards
v17 build up?

I have a ten year old Tartan 3500 that has has V17 applied every Spring; areas have peeled away leaving a less then smooth surface. Any suggestions? Is sanding to gel coat my only option, or is...
Showing results 1 to 8 of 8

 
 
For the best viewing experience please update your browser to Google Chrome