SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: Vasco
Forum: Gear & Maintenance 1 Week Ago
Replies: 20
Views: 1,220
Posted By Vasco
Re: in mast furling issue

When all the above advice fails get in your bosuns chair and go up to where it's jammed. Pull and tug until your fingers are bloody, use a plastic spatula to help get the sail out. You will have to...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 12
Views: 572
Posted By Vasco
Forum: Beneteau 2 Weeks Ago
Replies: 20
Views: 730
Posted By Vasco
Re: Tonnage Measurement Beneteau Oceanis 350 Year 1988

I thought I said that.
Although no tonnage survey is required for a boat this size in Canada the certificate of registry does show tonnage. There's a mathematical formula.

If you license the boat...
Forum: Beneteau 2 Weeks Ago
Replies: 20
Views: 730
Posted By Vasco
Re: Tonnage Measurement Beneteau Oceanis 350 Year 1988

Although no tonnage survey is required for a boat this size in Canada the certificate of registry does show tonnage. There's a mathematical formula.

My B393 comes in at GT 14.4 NRT 7.3
Forum: Beneteau 2 Weeks Ago
Replies: 20
Views: 730
Posted By Vasco
Re: Tonnage Measurement Beneteau Oceanis 350 Year 1988

If you're in Canada no tonnage survey required.
Forum: General Discussion (sailing related) 3 Weeks Ago
Replies: 18
Views: 604
Posted By Vasco
Re: Outboard oil mix specs

Use at least 50:1 TC3. Yamaha says 100:1 only because of EPA. In the same engine bought in the Bahamas (when they were still available in the US) they recommend 50:1 vs 100:1 in the States.
Forum: Seamanship & Navigation 3 Weeks Ago
Replies: 4
Views: 453
Posted By Vasco
Re: Navigating the Reefs of Andros

Definitely do not rely on Navionics in the Bahamas. I pointed out a whole lot of errors to them but they will not tell me whether they have corrected them. I have two of their chips of the Bahamas....
Forum: CS Yachts 3 Weeks Ago
Replies: 10
Views: 611
Posted By Vasco
Re: CS36 Merlin Bimini/Dodger Configuration

I have the wing keel "patented Hydrokeel" as CS puts it. She doesn't point the best. I don't race so it's not a significant factor for me. You need the deep keel for that. Also with the wing keel...
Forum: CS Yachts 3 Weeks Ago
Replies: 10
Views: 611
Posted By Vasco
Re: CS36 Merlin Bimini/Dodger Configuration

Dreamcast is very good and has made a dodger, bimini and full enclosure for a merlin in our club.
Dreamcast Marine Canvas Limited - Contact Us (http://www.dreamcastcanvas.com/contactus.htm)

I...
Forum: CS Yachts 3 Weeks Ago
Replies: 10
Views: 611
Posted By Vasco
Re: CS36 Merlin Bimini/Dodger Configuration

Mine (88 model #6236) is the same. That's why I've never put a bimini on it. I have a dodger extension which can only be used when not using the mainsail.
Forum: CS Yachts 3 Weeks Ago
Replies: 10
Views: 611
Posted By Vasco
Re: CS36 Merlin Bimini/Dodger Configuration

It all depends on where your traveller is. The Merlin was built with three different mainsheet traveller configurations. Early models had the traveller just forward of the pedestal, later models on...
Forum: Electrical Systems 3 Weeks Ago
Replies: 20
Views: 573
Posted By Vasco
Re: Voltage Drop Problem: battery, wiring or both

I agree the problem is from old wiring. But rather than change out the wiring harness it's much easier to install a relay. The relay does not mask the problem it fixes it without having to get a...
Forum: Electrical Systems 3 Weeks Ago
Replies: 20
Views: 573
Posted By Vasco
Re: Voltage Drop Problem: battery, wiring or both

It's for the engine control panel wiring. Installing a relay between the panel wiring and the solenoid will boost the voltage and it'll start every time you push the button. Here's the instructions...
Forum: Electrical Systems 3 Weeks Ago
Replies: 20
Views: 573
Posted By Vasco
Re: Voltage Drop Problem: battery, wiring or both

Common problem with wiring in older boats. Simplest solution is to install a relay. I finally bit the bullet and did that with my 26 year old boat. And I had new batteries! Get a relay from NAPA....
Forum: Boat Review and Purchase Forum 07-11-2014
Replies: 15
Views: 732
Posted By Vasco
Re: Boat Trucking from Northeast Coast to Great Lakes

If the boat is ready you can easily do the canal in a week from Waterford to Buffalo. Lots of daylight this time of the year. There are a few spots where you can leave the boat if needed. There...
Forum: Cruising & Liveaboard Forum 06-11-2014
Replies: 32
Views: 1,904
Posted By Vasco
Re: Cruising Permit

I think it's 12m not 15m.
Forum: Diesel 06-05-2014
Replies: 22
Views: 1,050
Posted By Vasco
Re: Yanmar 3GM30F

How's your fuel? 30,000 is a bit high for a 3GM30F :) maybe 3000.
Forum: Living Aboard 05-20-2014
Replies: 6
Views: 674
Posted By Vasco
Re: Looking for a good - easy to access - well priced marina in Georgia -

On the hard, St Marys is your best bet. Not Langs but the other marina there (Name escapes me right now). In the water, Brunswick Marina will beat all others , many Bahamas cruisers store there in...
Forum: Gear & Maintenance 05-18-2014
Replies: 8
Views: 644
Posted By Vasco
Re: Securing Dinghy on Davits with Motor

Get four ratchet straps. Two vertical lift tight to davits, two athwartships to prevent side to side movement. There should be absolutely no play. I do it all the time with a 10'06" RIB with a 15...
Forum: General Discussion (sailing related) 03-07-2014
Replies: 4
Views: 614
Posted By Vasco
Re: Bahamas

Hole #3 in Georgetown,in the water. Slips or a mooring.
Forum: Boat Review and Purchase Forum 03-05-2014
Replies: 51
Views: 2,501
Posted By Vasco
Re: CS36 Merlin Model Comparison

The Volvo 2000 series were the worst engines Volvo put out. A quick search will tell you all you want to know.
Forum: Cruising & Liveaboard Forum 03-05-2014
Replies: 6
Views: 608
Posted By Vasco
Re: Anchorage south of St Augustine.

The best (and only) anchorage in Cape Canaveral is just west of the lock in the Banana River. Anchor north or south of the west lock entrance. The north anchorage is better.

As for the Indian...
Forum: Boat Review and Purchase Forum 03-01-2014
Replies: 51
Views: 2,501
Posted By Vasco
Re: CS36 Merlin Model Comparison

Here's mine. Bought her in 1988, still have her. Hull number 36, Hydrokeel. Been south a few times but she stays in Lake Ontario now. A great boat. Got rid of the Volvo 2003 after the first trip...
Forum: General Discussion (sailing related) 02-17-2014
Replies: 203
Views: 8,333
Posted By Vasco
Re: Beaufort South Carolina no longer a free anchor

You might be right. I've been just anchoring south of Memorial Bridge and moving on in the morning. Been doing that for many years. Nothing much to attract me to the place. I do like that little...
Forum: General Discussion (sailing related) 02-16-2014
Replies: 203
Views: 8,333
Posted By Vasco
Re: Beaufort South Carolina no longer a free anchor

Actually Daytona is not a good stop on the Waterway. I only stop there because it's between St. Augustine and Titusville. There's not much there. No laundry, Publix, liquor store convenient to...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 01:00 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.