SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 11 of 11
Search took 0.01 seconds.
Search: Posts Made By: gramcko
Forum: Learning to Sail 12-24-2009
Replies: 12
Views: 1,259
Posted By gramcko
Close encounters

I also sail in Santa Monica bay. I've had 4 uncomfortably close encounters - as in change of pants close - only 1 of which I knew that a whale in area. For the past few years the whale season has...
Forum: Gear & Maintenance 01-03-2009
Replies: 17
Views: 1,735
Posted By gramcko
The time I was stuck in reverse it was the cable....

The time I was stuck in reverse it was the cable. Bent where it fell off the shift lever.
Forum: Gear & Maintenance 10-19-2008
Replies: 70
Views: 6,423
Posted By gramcko
One note, climbing harnesses are really hard on...

One note, climbing harnesses are really hard on the family jewels. Bosun's chairs are far better in that regard. I think there is a product that combines both, or at least has a canvas seat.
Forum: Learning to Sail 10-19-2008
Replies: 42
Views: 3,630
Posted By gramcko
bubb2's advice is right on. On my C30, I tie off...

bubb2's advice is right on. On my C30, I tie off my tiller and a bit of patience to balance with the traveler. Holds reach and close reach course beautifully, but I get bored after 20 minutes or so,...
Forum: General Discussion (sailing related) 08-27-2008
Replies: 46
Views: 2,933
Posted By gramcko
As sailingdog says use a spring line. It takes...

As sailingdog says use a spring line. It takes much of the angst out docking in a slip with a dead engine or without one. At worst you step off, loop around the outer most dock cleat and stop the...
Forum: Boat Review and Purchase Forum 08-01-2008
Replies: 25
Views: 2,515
Posted By gramcko
The 5 year age should be of little concern it...

The 5 year age should be of little concern it will not change your maintenance, repair, upgrade, and bone head mistakes costs. I've a late 70's C30 bought 3 and half years ago. I've average $225 /...
Forum: Boat Review and Purchase Forum 07-31-2008
Replies: 3
Views: 869
Posted By gramcko
I rewired my mast last Dec. The yard charged $125...

I rewired my mast last Dec. The yard charged $125 / hour for the crane, plus a mast cradle rate.
Forum: Atomic 4 07-31-2008
Replies: 20
Views: 9,175
Posted By gramcko
Gas on a sailboat is an unnecessary risk, go...

Gas on a sailboat is an unnecessary risk, go diesel, less headache, less hazard. Installation will cost about the same.

If you can afford somewhat more, and don't mind being the first on your...
Forum: Gear & Maintenance 07-23-2008
Replies: 13
Views: 1,411
Posted By gramcko
You mentioned "direct connect to battery". Just a...

You mentioned "direct connect to battery". Just a reminder, safest practice is a fuse very near to battery, or better yet through the electrical panel.

Anybody, is there a compelling reason to...
Forum: Gear & Maintenance 01-15-2008
Replies: 3
Views: 1,750
Posted By gramcko
Thanks Barry. Heat will be my next attempt....

Thanks Barry. Heat will be my next attempt. Though I'm a bit worried the silly thing has a hidden trick; because I tried liquid wrench and a pulley puller and only succeeded in popping the bolt heads...
Forum: Gear & Maintenance 01-15-2008
Replies: 3
Views: 1,750
Posted By gramcko
Yanmar PTO v-pulley

I need to remove the PTO v-pulley from a YSE 12 engine. It's either being very stubborn or it needs a special tool. Does anyone know if a special tool is needed? Secondly, does anyone know of a part...
Showing results 1 to 11 of 11

 

All times are GMT -4. The time now is 12:56 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012