SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 47
Search took 0.01 seconds.
Search: Posts Made By: bvermeer
Forum: Islander 03-15-2014
Replies: 6
Views: 1,663
Posted By bvermeer
Re: Beta 20 with Sea Prop 60 Saildrive

I think the transmission noise saga has finally come to a successful conclusion. Beta (and Beta Canada) stepped up to the plate and supplied a replacement Sea Prop 60 with a lower gear ratio and...
Forum: Islander 03-15-2014
Replies: 20
Views: 960
Posted By bvermeer
Re: Leak detection help-- I30 Bahama

Congratulations on a great boat. I've owned two, both '79s, and have rebuilt both from the ground up. And I agree with the comments posted so far, your best bet will be the hoses draining the cockpit...
Forum: Islander 03-15-2014
Replies: 20
Views: 960
Posted By bvermeer
Re: Leak detection help-- I30 Bahama

Congratulations on a great boat. I've owned two, both '79s, and have rebuilt both from the ground up. And I agree with the comments posted so far, your best bet will be the hoses draining the cockpit...
Forum: Islander 01-08-2014
Replies: 6
Views: 1,663
Posted By bvermeer
Re: Beta 20 with Sea Prop 60 Saildrive

Obviously the engine is going to make the same amount of noise connected to a direct shaft as it will with a saildrive unit. However, noise is caused by vibration and a considerable amount of noise...
Forum: Islander 01-08-2014
Replies: 6
Views: 1,663
Posted By bvermeer
Re: Beta 20 with Sea Prop 60 Saildrive

Thanks for the comment Gary. Yes, I've listened to another SeaProp and found the noise to be much less than my installation. Interestingly enough, that particular unit had a different gear ratio....
Forum: Islander 03-20-2013
Replies: 4
Views: 678
Posted By bvermeer
Re: Repowering a Bahama 30

I've had two Islander Bahama 30s, the first with an Atomic 4, the current with the original Volvo MD7A. The Volvo ran strong but was corroding from the inside (raw water cooling). I have just...
Forum: Diesel 03-19-2013
Replies: 18
Views: 651
Posted By bvermeer
Re: defining "rebuilt"

I tossed the "rebuild" idea around a long time before re-powering. The questions I asked were:

How long do I plan to keep the boat?
How old is the engine?
When was the engine designed and was it...
Forum: Diesel 03-19-2013
Replies: 20
Views: 2,415
Posted By bvermeer
Re: Beta Marine

As an end to this thread, Beta England has responded to my concerns regarding the ticking noise at low RPM in gear. The replacement (different) drive plate hasn't solved the problem yet. The noise...
Forum: Diesel 02-17-2013
Replies: 20
Views: 2,415
Posted By bvermeer
Re: Beta Marine

As mentioned earlier, I got a reply. Beta will be sending me a replacement drive plate (the shock absorbing device between the engine and transmission, located inside the bell housing at the rear of...
Forum: Diesel 02-14-2013
Replies: 20
Views: 2,415
Posted By bvermeer
Re: Beta Marine

Hey! I got a reply! I sent a third e-mail (this time to the sales department) and got an immedate reply from the technical department with an apology for failing to respond the previous two times. It...
Forum: Diesel 02-13-2013
Replies: 20
Views: 2,415
Posted By bvermeer
Re: Beta Marine

Twin Disc (the manufacturer of the Sea Prop 60) did respond in a timely manner. They sent my concern (and the sound file) to their technical department. The technical department replied with;...
Forum: Diesel 02-12-2013
Replies: 20
Views: 2,415
Posted By bvermeer
Re: Beta Marine

Yes I have. The sound file (which the Sailnet system won't allow me to attach) has the engine in and out of gear and the clicking noise is quite distinct and noticable. Unfortunately, the...
Forum: Diesel 02-11-2013
Replies: 20
Views: 2,415
Posted By bvermeer
Re: Beta Marine

The local distributor believes the noise to be "gear lash" out of the sail drive unit. But he doesn't know for certain as this is the first Sea Prop 60 that he has encountered. Although not a...
Forum: Diesel 02-10-2013
Replies: 20
Views: 2,415
Posted By bvermeer
Beta Marine

A year ago I installed a brand new Beta 20 with a Sea Prop 60 saildrive leg into my Islander Bahama 30, replacing an aging Volvo MD7A. I performed the installation myself with assistance and...
Forum: Islander 01-27-2013
Replies: 0
Views: 445
Posted By bvermeer
Islander Bahama 30 called "Dreamer"

Here's a challenge for this site. I'm looking for my pervious Islander Bahama 30called "Dreamer". Built in September of 1978 I purchased her in 1989 and was forced to sell in 1996 due to illness. The...
Forum: Islander 01-27-2013
Replies: 9
Views: 643
Posted By bvermeer
Re: New I30 owner--lines to cockpit

Nestor

Send me your e-mail and I can send you plenty of photos and documents on running everything into the cockpit. I've done it twice, two different Islander Bahama 30s. I single-handed all the...
Forum: Islander 01-27-2013
Replies: 6
Views: 773
Posted By bvermeer
Re: Moisture around chainplates

The chain plates on the Islander Bahama 30 are known to leak on a regular basis. I lift the small deck plates every spring and re-bed them with a Sikaflex sealer. I have also used 3M5200 but it's a...
Forum: Islander 01-27-2013
Replies: 4
Views: 349
Posted By bvermeer
Re: Islander 30 LPG tank size

Hi guys

I have one of the relatively new fiberglass tanks in the port side cockpit locker in a vented holder I built out of fiberglass. Although the tank is the same size as the standard 20 lb...
Forum: Islander 01-13-2013
Replies: 14
Views: 920
Posted By bvermeer
Re: I30 Mark II Profile Drawing

Your confusion has clarified the issue for me!! I did not realize that the "McGlasson" I30 was the original, older design, I've never seen one of them. So although Finch designed both the I 30 Mark...
Forum: Islander 01-13-2013
Replies: 14
Views: 920
Posted By bvermeer
Re: I30 Mark II Profile Drawing

John

Thanks so much for these drawings! With the sail actually showing the Mark II designation I have to take these as gospel at the time. Too bad there is no year listed. Interestingly, the...
Forum: Islander 01-08-2013
Replies: 14
Views: 920
Posted By bvermeer
Re: I30 Mark II Profile Drawing

Interesting! Sure looks like a Bahama. It's too bad the underbody isn't outlined, that would be the definitive view. Thanks for the info, I will add it to my collection.

Bert Vermeer
Forum: Islander 01-08-2013
Replies: 14
Views: 920
Posted By bvermeer
Re: I30 Mark II Profile Drawing

Interesting information, and not a whole lot of other people are jumping on this bandwagon just yet. It will take a bit of convincing that the I30 and the I30 Mark II don't share the same hull and...
Forum: Islander 01-05-2013
Replies: 14
Views: 920
Posted By bvermeer
I30 Mark II Profile Drawing

Hello fellow Islander owners!
Does anyone have a profile drawing of the Islander 30 Mark II? An interior layout drawing would also be very helpful. I have the I30 drawing and I'm trying to determine...
Forum: Islander 11-30-2012
Replies: 6
Views: 1,663
Posted By bvermeer
Beta 20 with Sea Prop 60 Saildrive

Hello all
Last spring I installed a Beta Marine 20 (Kabota 722 engine) with a Sea Prop 60 saildrive unit in my 1978 Islander Bahama 30, replacing the well used Volvo MD7A. I did the installation...
Forum: Boat Review and Purchase Forum 06-28-2012
Replies: 10
Views: 5,222
Posted By bvermeer
Re: Compare/Contrast Catalina 30 & Islander Bahama 30

Having owned two Islander Bahama 30s over the last 15 years I believe them to be excellent boats. I've sailed mine down the outside of Vancouver Island, British Columbia in a 40 knot following wind...
Showing results 1 to 25 of 47

 

All times are GMT -4. The time now is 02:58 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012