SailNet Community - Search Results
Advanced Search
Showing results 1 to 9 of 9
Search took 0.02 seconds.
Search: Posts Made By: arf145
Forum: Gear & Maintenance   06-05-2015
Replies: 48
Views: 3,335
Posted By SY JollyDodger
Re: 2-blade Flexofold Problems

To all of you harassing me about me sending E-mail. :wink

After talking with Keld the sales and Marketing manager on the Phone (earlyer), he urged me to contact him on E-MAIL telling him about my...
Forum: Diesel   02-01-2015
Replies: 25
Views: 4,376
Posted By bigdogandy
Re: Yanmar 3GM oil line failure

I just had the same problem - the oil feed line rusted through at the banjo fitting behind the fuel lift pump. It only took a few minutes to pump all the oil out of the engine and into the sump under...
Forum: Beneteau   01-21-2014
Replies: 4
Views: 753
Posted By svHyLyte
Re: Beneteau 343 2006 Salt water intake


Your through hulls are likely fine. (To satisfy yourself, however, polish a patch of your through hull will some light sand paper. If the underlying material is yellow/gold in color, your...
Forum: Diesel   11-17-2013
Replies: 267
Views: 79,218
Posted By Jacques-Andre
Re: Perkins 4.108M DIY Rebuild -- A Narrative

Don't you all worry.

He's fine, just has other things in his life than keeping us happy here! Its quite good that he managed to get that much time to devote to this project without someone...
Forum: Electronics   10-06-2013
Replies: 4
Views: 532
Posted By svinshallah
Re: Seatalk Cross Interference

First thing is to check ALL of the grounds associated with the system. Every one. Seatalk uses a common ground for -12V and the data ground. Bad grounds create noise on the Seatalk bus.
Forum: Chesapeake Bay   07-20-2013
Replies: 5
Views: 617
Posted By Gladrags1
Re: Knapps Narrows

It would be tight, especially around the R4 on the western side. They have installed a new green buoy to help - you need to stay real close to the R4 and turn sharply afterwards. It can be done with...
Forum: Gear & Maintenance   07-02-2013
Replies: 11
Views: 933
Posted By chef2sail
Re: Refill Propane?

Ace hardware is where we go. Many have refill stations . If you are near Deale which I think you are try Amerigas, Ferrelgas, ask in your marina. Make sure you have a modern tank with pressure...
Forum: Gear & Maintenance   07-01-2013
Replies: 4
Views: 476
Posted By PAULCR1
Rounded bolts and/or nuts

I don't know if it's o.k. to mention a specific product or not but I'll try. I had a 17mm bolt that ran into the rear of my Universal engine. The bolt held a bracket that had rusted through. First...
Forum: Diesel   11-25-2011
Replies: 25
Views: 4,376
Posted By jrd22
Yanmar 3GM oil line failure

My brother and I installed a new 3GM in the early 90's and apart from normal maintenance it's been trouble free and still looks almost new. A few weeks ago it was run while in the slip for about 20...
Showing results 1 to 9 of 9

For the best viewing experience please update your browser to Google Chrome