SailNet Community - Search Results

   Search Sailnet:

 forums  store  

Quick Menu
Boat Reviews  
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Hatches and Portlights
Interior And Galley
Marine Electronics
Other Items
Plumbing and Pumps
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here

Go Back   SailNet Community > Search Forums
 Not a Member? 

Showing results 1 to 25 of 51
Search took 0.02 seconds.
Search: Posts Made By: bblument
Forum: Gear & Maintenance 1 Week Ago
Replies: 25
Views: 1,619
Posted By svHyLyte
Re: I had to cut away my anchor :(

We used the same mount on our Cal 2-29 for 20+ years to mount a Fortress FX16 without difficulty. We originally used a length of Velcro to lock the Palm in the mount. Later, I drilled a 3/16" hole...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 40
Views: 2,576
Posted By asdf38
Re: Dinghy and Engine Choices

I went through a few iterations trying to find the right dingy for my Contessa 26.

I've had an $80 "Sevylor Fish Hunter 3-Person" since I bought the boat. This fits comfortably in a locker in the...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 15
Views: 942
Posted By capta
Re: Deck Fittings?

It's what I've been using since the early 60's, without a failure of any kind. I read about the butyl when I first saw it discussed on here but honestly, I haven't tried it. I have never said...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 32
Views: 1,611
Posted By tschmidty
Re: Whisker pole?

JonEisberg, that's great info.

for the OP, I'd certainly just go with the pole you are looking at. It has a straight spike at the end which you just run through the clew, no clipping in necessary....
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 32
Views: 1,611
Posted By JonEisberg
Re: Whisker pole?

Sorry, I think that's a bad idea... And frankly, I don't see how it's possible on anything but smaller boats, in the most benign conditions...

Well, I just watched the first couple of...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 32
Views: 1,611
Posted By TakeFive
Re: Whisker pole?

I'm sure glad I didn't see the Sailnet store listing, because that pole is exactly what I have on my 25' boat, and I'm glad I bought it four years ago.

Don't sell yourself short. You're asking...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 32
Views: 1,611
Posted By weinie
Re: Whisker pole?

The fitting on the mast for the pole should be installed level with the clew of the sail when flying. Hence the pole would horizontal. The pole should be as long as the foot. If you have a large...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 32
Views: 1,611
Posted By SVAuspicious
Re: Whisker pole?

On my boat when I get deep the tack line/foreguy is really long (pole aft) by the time I'm ready to gybe and there is a whole lot of sail out there. Inside gybes are tricky shorthanded and I can't...
Forum: General Discussion (sailing related) 3 Weeks Ago
Replies: 40
Views: 2,066
Posted By TakeFive
Re: Fellow Four Eyes dealing with rain

I suggest you wear an eyewear retainer. We have several on the boat for me, my wife, and guests. They look nerdy, but they've saved my glasses a few times. They're up there with pfd and sunscreen in...
Forum: Learning to Sail 08-16-2014
Replies: 61
Views: 4,074
Posted By svzephyr44
Re: Does a sailboat need a travler?

Do you need a traveler - no. But lets look at the entire setup for a moment. When adjusting a sail you have three objectives:

1. To adjust the "draft." This is the center of effort of the sail and...
Forum: General Discussion (sailing related) 08-16-2014
Replies: 156
Views: 7,425
Posted By FSMike
Re: Give AIS a rest

If you are under sail you are going to be on either port tack or starboard tack regardless of whether you are on a run or close hauled or any other point of sail.
Which tack you are on is determined...
Forum: Pearson 08-14-2014
Replies: 2
Views: 411
Posted By CalebD
Re: P26 Sanitation Vent Location

Having read Peggy Hall's book(let) on "Eliminating boat odors"...
There are a few things to consider.

Ideally your vent line will be as straight and short as possible. This can be difficult on...
Forum: General Discussion (sailing related) 08-13-2014
Replies: 38
Views: 2,044
Posted By SVAuspicious
Re: Downwind Sailing

As noted above, sailing deeper than a broad reach is all about projected area. If your gennaker is larger than your main you are likely to go faster with the main down and just the gennaker up.

Forum: General Discussion (sailing related) 08-13-2014
Replies: 38
Views: 2,044
Posted By Tempest
Re: Downwind Sailing

Simply put, it sounds like you were over-powered with too much sail up. The mainsail wants to drive you upwind and you have apply alot of helm ( rudder) to keep your heading downwind. Reefing...
Forum: Gear & Maintenance 08-11-2014
Replies: 8
Views: 606
Posted By hriehl1
Re: jib sheets + clew

Start with a 30 +/- inch rope for the tail at each jib's clew.

Attach to the clew with an estar hitch, making each jib's permanently attached tail. A bowline would probably do as well as the estar...
Forum: Gear & Maintenance 08-09-2014
Replies: 8
Views: 606
Posted By hriehl1
I have a 2 foot long tail permanently attached to...

I have a 2 foot long tail permanently attached to the clew of each headsail with an estar hitch (modified buntline hitch). The jibsheet is one continuous line, with the clew-tail tied to the...
Forum: General Discussion (sailing related) 08-08-2014
Replies: 76
Views: 5,403
Posted By Jeff_H
Re: Pros and cons for a double ender/Canoe Stern

I apologize in advance that this is quite long and I worte it for another purpose but it is a detailed discussion of double enders which starts with a bit of history.

When you look at really old...
Forum: General Discussion (sailing related) 08-07-2014
Replies: 18
Views: 809
Posted By svHyLyte
Re: Rigging question….


I suggest the caulk simply because water is a particularly effective/aggressive solvent and particularly so if one is moored in an area where one's rig is likely to be exposed to soot or...
Forum: General Discussion (sailing related) 08-06-2014
Replies: 34
Views: 1,862
Posted By PaulinVictoria
Re: single-hand: best time raise/lower jib?

I always raised the main directly into wind (slugs get stuck otherwise), then turned off onto a very close haul on starboard tack. Tighten the port sheet up a bit (not too much) and hoist the jib. ...
Forum: Gear & Maintenance 08-04-2014
Replies: 11
Views: 758
Posted By DGA
Re: Help installing a line boom vang

1, 45 degrees will give you the best boom pull for the least effort from you. 2, not always a good idea to try to bolt something tightly through a hollow section such as a boom. Better to use large...
Forum: Gear & Maintenance 07-28-2014
Replies: 26
Views: 878
Posted By svHyLyte
Re: Headset Communicators?


We sail a 42' yacht and are moored in a basin that is very tight and so requires deft handling. Initially, my wife refused to take the wheel at all until we were well clear of the marina....
Forum: General Discussion (sailing related) 07-24-2014
Replies: 40
Views: 2,182
Posted By Shinook
Re: Another fatal attempt at "Youngest to circumnavigate"

Regarding instrument flying...

Flying instruments really isn't that hard, but it takes a lot of proficiency and training to get used to the environment. In general aviation, there are a LOT of...
Forum: General Discussion (sailing related) 07-21-2014
Replies: 86
Views: 4,507
Posted By Jeff_H
Re: Tiller or Wheel for Solo?

Your comments are very valid, and relevant to the discussion at hand. I personally welcome and am interested in your comments and would have even if they did not essentially concur with my own. ;)
Forum: Pearson 07-21-2014
Replies: 8
Views: 437
Posted By Stumble
Re: P26 Genoa track and cars

I sounds like some sort of hash up by a PO, or a weird installation. Track ends are supposed to be removable, and with a minimum of fuss, but obviously that doesn't sound like what you have.

Forum: General Discussion (sailing related) 07-04-2014
Replies: 62
Views: 4,140
Posted By Alden68
Re: What is proper dingy etiquette?

Bb assuming your boat in either on a mooring or at a slip you can and should leave your motor up. The motor does not want to be immersed in salt water for long periods of time.

Now, if your p 26...
Showing results 1 to 25 of 51


All times are GMT -4. The time now is 09:08 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) LLC 2000-2012

The store is owned and operated by a company independent of the forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.