SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 272
Search took 0.06 seconds.
Search: Posts Made By: roline
Forum: Diesel 12-08-2013
Replies: 18
Views: 4,071
Posted By roline
Re: Balmar Alternator Eating Belts

I installed a Yanmar 80 amp alt on a 2GM20. I consider this to be the very upper limit for a single belt drive. I keep a couple spare belts on board, but the current belt has over 50 hrs on it and...
Forum: Gear & Maintenance 12-08-2013
Replies: 37
Views: 2,293
Posted By roline
Re: Rolly Tasker vs US-based

I priced a new light #1 from several lofts and went with a RT sail from Derk at National Sail supply. It was a perfect fit for the boat and I ended up winning more races in light air. It is still...
Forum: Gear & Maintenance 08-05-2011
Replies: 53
Views: 3,970
Posted By roline
Stove Stowage

I switched from pressure alchohol to LPG, included the leakage sniffers to monitor and control LPG flow. Mounted the stove on slides to access lost stowage behind it.
Its been working great for yrs,...
Forum: Gear & Maintenance 08-05-2011
Replies: 7
Views: 4,079
Posted By roline
Barrient 22 ratio 1:1 5.4:1 ...

Barrient 22
ratio 1:1 5.4:1
12" 7.6 to 1, 40.8 to 1
10" 6.3 to 1 34 to1
8" 5.1 to 1 27.2 to 1

22ST is different
Forum: Gear & Maintenance 04-22-2011
Replies: 21
Views: 4,645
Posted By roline
ice box to refer conversion

I needed a larger ice box, so I decided that I needed less ice. I took the guts of a Norcold unit and adapted it to the ice box. It was charged with the commercial freon from the car parts store. For...
Forum: Gear & Maintenance 12-31-2010
Replies: 12
Views: 1,151
Posted By roline
Stay with the decay-insect resistant tropical...

Stay with the decay-insect resistant tropical woods, Poplar is a weak hardwood, if you insist on domestic hardwoods, maple-oak-hickory are some of the stronger / harder ones. Walnut is hard to work...
Forum: Gear & Maintenance 12-22-2010
Replies: 14
Views: 1,776
Posted By roline
I rebuilt the main halyard exit sheave for my...

I rebuilt the main halyard exit sheave for my Santana525, because no one made a replacement. I modified a Harken ball-bearing wire sheave to accept 5/16 rope and replaced the hollow stainless axle...
Forum: Gear & Maintenance 11-10-2010
Replies: 25
Views: 5,899
Posted By roline
I designed a custom shape holding tank to fit...

I designed a custom shape holding tank to fit just behind the head to minimize all of the hose lengths. The boat came with a bladder tank under the V-berth, bad idea...... SOlution was 15 gallons, 12...
Forum: Gear & Maintenance 10-16-2010
Replies: 26
Views: 2,496
Posted By roline
Cal 9.2 head

A couple pics of the custom holding tank installation
Forum: Gear & Maintenance 10-16-2010
Replies: 26
Views: 2,496
Posted By roline
The Cal 9.2 came with a new bladder tank. After...

The Cal 9.2 came with a new bladder tank. After 1/2 season, I knew it had to go. I designed a custom tank to mount right behind the head and replaced it all. Tank, hoses and head. problem solved....
Forum: Gear & Maintenance 09-29-2010
Replies: 25
Views: 5,652
Posted By roline
Propane stove with extra stowage

I replaced the Kenon alcohol with a Force 10 2 burner with Broiler stove. The shelf it was on waited the stowage behind it. I designed a slide out mount and placed a stowage box behind for pots/pans...
Forum: Gear & Maintenance 09-29-2010
Replies: 18
Views: 5,145
Posted By roline
The conventional flax packing that I had was over...

The conventional flax packing that I had was over 6yrs old, just the fibers remained. I re-packed with GFO, took 1/2 hr and I would not recommend anything else. This stuff is great!! So far no...
Forum: Gear & Maintenance 08-01-2010
Replies: 3
Views: 1,815
Posted By roline
Always, always, dig the soft coring out around...

Always, always, dig the soft coring out around any hole and fill with a thickened epoxy, top side or bottom side:
* To create a solid incompressible wall to prevent the loss of clamp load from the...
Forum: Gear & Maintenance 07-21-2010
Replies: 1,138
Views: 363,581
Posted By roline
Completed the Tortuga Triangle Trip in May, GPS...

Completed the Tortuga Triangle Trip in May, GPS worked without issue. Back light worked for Nav at night, almost a little too bright. Found the company out in California that supplied the multi-pin...
Forum: Gear & Maintenance 07-21-2010
Replies: 6
Views: 665
Posted By roline
I have Interlux fiberglass bottom coat...

I have Interlux fiberglass bottom coat (black-hard) under ablative micron paint. When the shark gray color turns black, its time to do the bottom.
My other boat has VC 17 over top the VC tar.
The...
Forum: Gear & Maintenance 07-21-2010
Replies: 14
Views: 5,208
Posted By roline
I learned that it will also eat the finish off of...

I learned that it will also eat the finish off of a bow. I was only 17 up in Canada where everything that flies bites and the only area that was free for a meal was around my hand, palm where I could...
Forum: Gear & Maintenance 07-17-2010
Replies: 32
Views: 5,574
Posted By roline
FLAX Packing replacement with GFO

Just completed an in the water packing gland transplant. The old flax rings would squeak at low speed, always leaked at the dock and at speed. The packing could not be tightened further. When I...
Forum: Gear & Maintenance 06-14-2010
Replies: 4
Views: 608
Posted By roline
My boat Cal 9.2 had a set of Barient 25 winches....

My boat Cal 9.2 had a set of Barient 25 winches. I wanted self tailing and scrounged Ebay for 6yrs until I found a pair of Barient 27-48's. They had the same base dia and drum dia as the 25's. I...
Forum: Gear & Maintenance 06-07-2010
Replies: 5
Views: 873
Posted By roline
I'm a firm believer of the Interlux InterProtect...

I'm a firm believer of the Interlux InterProtect 2000E/2001E Epoxy Primer as the last barrier coat underneath the bottom paint, except not for vinyl VC paints. A quick scuff of the existing epoxy for...
Forum: Gear & Maintenance 06-07-2010
Replies: 16
Views: 1,168
Posted By roline
I put 2 100AH AGM's in the house bank. That was...

I put 2 100AH AGM's in the house bank. That was 6yrs ago and they still performing well. Advantage is the AGM's have a quicker charge acceptance, so they can absorb the charge quicker that the...
Forum: Gear & Maintenance 06-05-2010
Replies: 17
Views: 1,325
Posted By roline
We from the place of fun and sun don't always...

We from the place of fun and sun
don't always flush for #1,
We would be pleased if you do
Always flush for #2.

Sign from the BVI
Forum: Gear & Maintenance 05-31-2010
Replies: 5
Views: 1,926
Posted By roline
The Yanmar engines (2GM20 also) filter has a bolt...

The Yanmar engines (2GM20 also) filter has a bolt with phillips head slots and a copper washer and a smaller screw with a plastic washer for the bleed screw. IF you use the larger bolt, the copper...
Forum: Gear & Maintenance 05-31-2010
Replies: 8
Views: 1,976
Posted By roline
Propane can be found with an oil additive that...

Propane can be found with an oil additive that prevents the steel tanks from rusting. We discovered that we were creating a lot of CO at work to the point of excessive CO buildup in the blood, dizzy...
Forum: Gear & Maintenance 05-31-2010
Replies: 6
Views: 1,936
Posted By roline
I was able to remove the 40 gallon tank in my Cal...

I was able to remove the 40 gallon tank in my Cal 9.2 and take it home for cleaning. There was a little bit of brace and reinforcement removal to get it out. After a week of multiple weak bleach...
Forum: Gear & Maintenance 05-31-2010
Replies: 16
Views: 1,987
Posted By roline
Both polyester and epoxy resins have an...

Both polyester and epoxy resins have an exothermic reactions to release energy to obtain a stable lower energy level which happens to be a crosslinked solid. Polyester resins can even crosslink in...
Showing results 1 to 25 of 272

 

All times are GMT -4. The time now is 03:20 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.