SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 25
Search took 0.01 seconds.
Search: Posts Made By: gsyversen
Forum: Gear & Maintenance 07-07-2008
Replies: 13
Views: 9,100
Posted By gsyversen
if it drops one cause of air that would be...

if it drops one cause of air that would be permanent though right, mine works just fine during normal use, its just switching from forward/reverse to neutral and just for I'd say a second...
...
Forum: Gear & Maintenance 07-07-2008
Replies: 8
Views: 946
Posted By gsyversen
I'v noticed that its not so much cold engine on...

I'v noticed that its not so much cold engine on mine but when I quickly take it from forward to reverse, like when docking... or when just quickly putting it in neutral from...
Forum: Gear & Maintenance 07-02-2008
Replies: 13
Views: 9,100
Posted By gsyversen
got referred to this thread on my post about...

got referred to this thread on my post about similar vibration, did you ever figure out what was causing this ? also how do you check the idle speed my manual wasn't clear enough for me :)

hope...
Forum: Gear & Maintenance 07-02-2008
Replies: 8
Views: 946
Posted By gsyversen
interesting article, I'll post there to see how...

interesting article, I'll post there to see how they adjusted/found how much slack there was.... thanks all !
Forum: Gear & Maintenance 06-30-2008
Replies: 11
Views: 1,283
Posted By gsyversen
found a good article on rubbaweld... its almost...

found a good article on rubbaweld... its almost as expensive as a new one but I want to try it out this weekend and there are none locally. I like the heat shrinking and I might do both and see how...
Forum: Gear & Maintenance 06-30-2008
Replies: 8
Views: 946
Posted By gsyversen
gearbox oil is fine, thogh I'm planning on...

gearbox oil is fine, thogh I'm planning on replacing it soon, and I dont think somethings around the shaft. I had a look under the boat and a diver was on it just a few days ago, it was only...
Forum: Gear & Maintenance 06-30-2008
Replies: 3
Views: 877
Posted By gsyversen
well that wors out best, if it works out :) I...

well that wors out best, if it works out :) I heard that there are special shop tools needed to get it water tight again but that seems silly if its a kit for regular folks... I might try that, is...
Forum: Gear & Maintenance 06-29-2008
Replies: 3
Views: 877
Posted By gsyversen
raw water rebuild shop ?

Hey all, does anyone know of a shop who does pump rebuilds ? My local will but I found that shopping around sometimes makes worth the time. Since I have a new pump I'm good but want to repair the old...
Forum: Gear & Maintenance 06-29-2008
Replies: 11
Views: 1,283
Posted By gsyversen
Great, for some reason I saved the old powercord...

Great, for some reason I saved the old powercord which had a split in it and used the end.... I'm taking it up with electrical tape next time I'm at anchor and nothing else to do, many thanks !
Forum: Gear & Maintenance 06-29-2008
Replies: 8
Views: 946
Posted By gsyversen
Vibration from forward to neutral

Hey all, had a nice weekend sailing but noticed something new docking today. I went forward on slow/idle (slowest forward) and went to neutral, when we came to a stop there was a big ruckus from the...
Forum: Gear & Maintenance 06-26-2008
Replies: 11
Views: 1,283
Posted By gsyversen
generator adapter

Hey all, I just got a portale camping generator to keep on the boat to charge battery and so on but I need a adapter from the standard 110 outlet on the charger to the 30A shorepower cord. I googled...
Forum: Gear & Maintenance 06-18-2008
Replies: 3
Views: 950
Posted By gsyversen
thanks Quickstep, I dont think thats what mine...

thanks Quickstep, I dont think thats what mine looks like. I dont think it had the threads on it like this one does... I didnt look too closely inside but that might give a clue too, lastly mine was...
Forum: Gear & Maintenance 06-18-2008
Replies: 3
Views: 950
Posted By gsyversen
raymarine Windvane

Hello all, I have a Beneteau 361 99 and its not equipped with a wind vane. I'd really like to get one and was looking at wireless, however today I changed the anchor light and found there is some...
Forum: Gear & Maintenance 06-13-2008
Replies: 7
Views: 3,910
Posted By gsyversen
ok I think I'm read for this one of these days

Installed my new rwa water pump today and found where the second filter is and I think I identified both pumps and bleeders on engine. I also drained the primary and a lot of water came out, no color...
Forum: Gear & Maintenance 06-13-2008
Replies: 24
Views: 7,317
Posted By gsyversen
hey all, got the pump today and before heading...

hey all, got the pump today and before heading down there I compared the numbers and its the exact same pump I had before... If this one last another 10 years I'm fine with that over $350 more for...
Forum: Gear & Maintenance 06-11-2008
Replies: 7
Views: 3,910
Posted By gsyversen
good article

thanks for referring me to that page artbyjody. My engine looks different so I dont know what is the same and not but all this is when changing any of the filters ??

anyone has anything specific...
Forum: Gear & Maintenance 06-11-2008
Replies: 7
Views: 3,910
Posted By gsyversen
Oh and also, anyone know the model # to replace...

Oh and also, anyone know the model # to replace the Racor 110 which has the see thru inspection cup rather than the metal housing ? I also have a heater so I use 2 outs and the one in....
Forum: Gear & Maintenance 06-11-2008
Replies: 7
Views: 3,910
Posted By gsyversen
Fuel filter replacement on Yanmar 3GM30F

hello all, I'm working on a raw water pump project on another post here and got great feedback. I also want to replace my fuelfilters but still not 100% sure how that goes. Doing some other work on...
Forum: Gear & Maintenance 06-11-2008
Replies: 24
Views: 7,317
Posted By gsyversen
ok found the second blade, it was blocking the...

ok found the second blade, it was blocking the hose going into the heat echanged and visible after removing the hose from it... my pliers were too small to get in there so I took the cap off, easy...
Forum: Gear & Maintenance 06-09-2008
Replies: 24
Views: 7,317
Posted By gsyversen
thanks Beej

great post Beej and getting a kind word in addition to experienced hel is great. your right, its part of the fun but I was expecting a small little maintenance and it turned into a piece lodged into...
Forum: Gear & Maintenance 06-08-2008
Replies: 24
Views: 7,317
Posted By gsyversen
I'll start digging thru the engine

I thought there might be somewhere it would get stuck. I have the shop manual but the pictures are hard to read, atleast for me, and I'm not that mechanically savvy yet.... I thought the fuel filter...
Forum: Gear & Maintenance 06-08-2008
Replies: 24
Views: 7,317
Posted By gsyversen
removed pump and big oops

ok, I removed the pump today, pretty easy... opened it to inspect the impeller and found that two wings are missing. I'm was terrified where they could have gone so I started looking thru the hose...
Forum: Gear & Maintenance 06-05-2008
Replies: 24
Views: 7,317
Posted By gsyversen
great advice everyone !

I'll try some of these ideas before I invest too much $$... I also got someone saying the old pumps are still avaliable at far more reasonable price but might have a different impeller. I'm taking it...
Forum: Gear & Maintenance 06-05-2008
Replies: 24
Views: 7,317
Posted By gsyversen
Like the sound of that...

but how can you really tell, this is an important part and its 10 years old... what is the life expectancy for this thing and do I invest in a kit for then to find out the bearings are gone... or...
Forum: Gear & Maintenance 06-05-2008
Replies: 24
Views: 7,317
Posted By gsyversen
raw water pump leak on Yanmar 3Gm30F

hello all, I'm new to this forum and seen many posts about my engine so I'm hoping someone here can help me... a few weeks ago I noticed water in the engine bilge and found the source to be a drip...
Showing results 1 to 25 of 25

 

All times are GMT -4. The time now is 04:08 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.