SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 28
Search took 0.02 seconds.
Search: Posts Made By: last mango
Forum: Gear & Maintenance 09-10-2014
Replies: 60
Views: 2,807
Posted By last mango
Re: Marina Electrical Problems

the boxes are made by Midwest with 2 30 amp on the box with breaker on each. Made for marina. Yes these docks have gone under with storms in the past. They don't seem too concerned and blame the...
Forum: Gear & Maintenance 09-09-2014
Replies: 60
Views: 2,807
Posted By last mango
Marina Electrical Problems

The marina which is also our home seems to have above normal electrical problems with their power boxes we connect to. Over the summer a couple of the power boxes have caught fire or over heated to...
Forum: Gear & Maintenance 08-18-2014
Replies: 29
Views: 2,373
Posted By last mango
Re: Should a Roller Furler be Hard?

Been reading through these and other threads and have a few things to check out. That said, I have an Endeavour 38 and it has a Harken Mk IV I think but the drum is the smaller one. I have not...
Forum: Gear & Maintenance 07-01-2014
Replies: 37
Views: 1,645
Posted By last mango
Re: A quick inverter question

Still doing some trolling around on some of these inverters but my boat came with a Heart inverter and have some doubts if it's tied in correctly. One thing it does if you disconnect from shore...
Forum: Gear & Maintenance 06-15-2014
Replies: 50
Views: 7,371
Posted By last mango
Re: Bilge pump non return valve.

Been reading lot of posts on this subject. Just put in a West Marine centrifugal pump with electronic float switch. I know I won't put in a check valve after reading. The deep section of the bilge...
Forum: Gear & Maintenance 04-17-2014
Replies: 2
Views: 444
Posted By last mango
Replacing Seacocks

Wanting to replace some older Groco valves that you can't get parts for anymore. Should I replace the thru hulls at the same time or can I just replace the valve if the thru hull is not showing any...
Forum: Endeavour 03-24-2014
Replies: 5
Views: 733
Posted By last mango
Re: Shower Plumbing Endeavour 33

not sure how your boat is set up, but on our Endeavour 38 the shower drain switch is located in the head. Simple on/off switch located by the vanity. Pump is in cabinet under the sink.
Forum: Gear & Maintenance 03-10-2014
Replies: 9
Views: 547
Posted By last mango
Re: 110 Breaker tripping question

well figured it out and found one on the Sailnet store. It's called a 30 amp breaker with a reverse polarity trip coil on it. So if reversed won't let the power through. Paneltronics makes them. ...
Forum: Gear & Maintenance 03-10-2014
Replies: 9
Views: 547
Posted By last mango
Re: 110 Breaker tripping question

that would be my way of thinking too but it's sure set up that way and looks original. The blocks are separate but are pinned together. Can't find a brand name on it. Just has paper spec tags, so...
Forum: Gear & Maintenance 03-10-2014
Replies: 9
Views: 547
Posted By last mango
Re: 110 Breaker tripping question

thanks - now the trick may be to find the breaker, this one is a single toggle on top but it's 3 breakers hooked together. Can see the feed cable coming in with the green, white and black with one...
Forum: Gear & Maintenance 03-09-2014
Replies: 9
Views: 547
Posted By last mango
110 Breaker tripping question

Always been fine on the boat running normal stuff TV's, AC, water heater. Been through the winter and had heaters running instead of ac. All of a sudden when came back to the boat after being gone...
Forum: Electrical Systems 09-12-2013
Replies: 6
Views: 474
Posted By last mango
Re: Inverter Question

Maine Sail

Been doing as you suggest as part of my pre flight checklist and just flip the AC power switch. Wiring is still off. Good fall project to clean it
thanks
Forum: Electrical Systems 09-12-2013
Replies: 6
Views: 474
Posted By last mango
Re: Inverter Question

the battery has a cluster of wires that need to be sorted out. I don't think any from the battery switch are going to the inverter. Pretty sure I just need to start over. Batteries have way too...
Forum: Electrical Systems 09-12-2013
Replies: 6
Views: 474
Posted By last mango
Inverter Question

When I bought this boat found out it appears the Xantrex inverter is wired where when power is disconnected from the shore power it automatically tries to run all the 110 V systems. Shouldn't there...
Forum: Electrical Systems 08-18-2013
Replies: 14
Views: 940
Posted By last mango
Re: Stupid solar question

So if you add panels, do you use a cut off switch while sitting at a docks and the boat is hooked to shore power and battery chargers? Looking to add some to mine and just in the planning and...
Forum: Gear & Maintenance 08-18-2013
Replies: 7
Views: 518
Posted By last mango
Re: Harken Roller Furlers

looking through the manuals it shows Cruising unit 1 or 2. Pretty sure mine is the unit 1 which would be the smaller drum. Just looking at the various parts it does look like it could interchange...
Forum: Gear & Maintenance 08-17-2013
Replies: 7
Views: 518
Posted By last mango
Harken Roller Furlers

Have an Endeavour 38 that the PO put a new Harken furler on before I bought her. That part could be a plus, but it's undersized. By the time you unwind the sail the drum is way full and you have to...
Forum: Gear & Maintenance 08-17-2013
Replies: 61
Views: 45,280
Posted By last mango
Re: Honda eu2000i and air conditioning

odd ball question = where is everyone storing these when underway - lazarettes, strapped to the decks/ One of our big problems to figure out
thanks
Forum: Gear & Maintenance 04-30-2013
Replies: 3
Views: 409
Posted By last mango
Mermaid AC Question

AC unit - Mermaid - at times it's cooling and then it quits. Fan runs and cycles. Water flow is steady out the side of the boat. How do you tell if the compressor is kicking on along with the fan....
Forum: Gear & Maintenance 04-15-2013
Replies: 15
Views: 1,215
Posted By last mango
Re: Batteries - Replacement

I'm in the process of putting in 4 six volt batteries. I've used 2 in a series but looking for how to wire up 4. Know positive to negative. Do you hook up the actual feeds off positive and...
Forum: General Discussion (sailing related) 04-15-2013
Replies: 31
Views: 2,466
Posted By last mango
Re: Overpropped; What to do?

Hey Chuckles
I'm there on a daily basis. If you learn by your mistakes I am a candidate for Mensa. Another few years and I'm equal with Einstein. Korn; I would have to go out again and write the...
Forum: General Discussion (sailing related) 04-14-2013
Replies: 31
Views: 2,466
Posted By last mango
Re: Overpropped; What to do?

Chuckles - wondering if you got your boat in water yet to see what RPM's turning. I have an Endeavour 38 I recently got with the yanmar 44hp 4JHE engine. Wondering if it has some fuel/injector...
Forum: Gear & Maintenance 03-17-2013
Replies: 0
Views: 516
Posted By last mango
Raritan Sea Era Head

Just finished the fun filled job of taking out the old head and holding tank on my Endeavour 38:eek:. Replaced with all new everything and use the Raritan Sea Era head. After a lot of clean up and...
Forum: Gear & Maintenance 03-08-2013
Replies: 10
Views: 1,006
Posted By last mango
Re: Check Valves on Heads

this is an endeavour 38 and one of those molded and glassed in units. I will make a Y coming out of the tank where it will option pump out or overboard. Not to sound stupid which I am, but the...
Forum: Gear & Maintenance 03-08-2013
Replies: 10
Views: 1,006
Posted By last mango
Re: Check Valves on Heads

I just got this boat few months ago and had been sitting up awhile. Other boat I had I could change the joker easily. figured I would just start over from scratch and fix some things better. The...
Showing results 1 to 25 of 28

 

All times are GMT -4. The time now is 10:45 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.