SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 168
Search took 0.09 seconds.
Search: Posts Made By: Mechsmith
Forum: Seafarer 2 Weeks Ago
Replies: 2
Views: 976
Posted By Mechsmith
Re: replacing Bomar hatch in 1979 Seafarer 23

I found a hatch that was a half inch narrower in a salvage place. Then I reduced the size of the port by 1/4" on each side and got on with the program.
Forum: Looking for Companionship... 09-18-2014
Replies: 4
Views: 407
Posted By Mechsmith
Re: sailing boca grande

Yes, I have found three sailing buds or belles there. One not so good, one pretty good, and one that I spent a couple months sailing with. Also post a sign at all the senior centers and athletic...
Forum: Looking for Companionship... 09-17-2014
Replies: 4
Views: 407
Posted By Mechsmith
Re: sailing boca grande

John, I'd also try the personals in Ft. Myers, Punta Gorda, and Cape Coral. I have had fair luck there.
Forum: Cruising & Liveaboard Forum 09-17-2014
Replies: 19
Views: 4,085
Posted By Mechsmith
Re: Collecting Rain water

On the East coast US. rainwater is often not fit to drink. Acid rain and other pollutants are in most small thunderstorms. After a pretty good rain the atmosphere cleans up along with your sails. I...
Forum: Diesel 08-24-2014
Replies: 8
Views: 423
Posted By Mechsmith
Re: 1GM10 won't run over ~2500rpm

Rocketer, you are over propped, or have a plugged exaust. If a diesel smokes more than briefly it's being overloaded. This will either "tulip" the valves or put a hole in the piston sooner or...
Forum: General Discussion (sailing related) 07-03-2014
Replies: 14
Views: 688
Posted By Mechsmith
Re: Need tips on moving a small wooden Catspaw Dinghy from R.I. to CA

Try U-Haul if you are driving. It would also fit in a full size van. Lots of ways to skin a small boat. A car trailer also would work. Depends a lot on what else has to go and the money availiable...
Forum: Gear & Maintenance 06-17-2014
Replies: 9
Views: 516
Posted By Mechsmith
Re: Mast-attached winch problem

Most Auto Parts stores stock "Heli Coils". I'd investigate those first. If you have a suitable place for them they are better than new. For instance they are used extensivly in aluminum cylinder...
Forum: Engines 06-13-2014
Replies: 2
Views: 363
Posted By Mechsmith
Re: fuel pump repairs

They are not taboo. The difficulties are largely the high degree of cleanliness required and since they fail pretty rarely parts aren't easily availiable.

In the last 50 years I have never had...
Forum: Diesel 05-05-2014
Replies: 9
Views: 433
Posted By Mechsmith
Re: 1977 ODAY Repowering options Questions

I have a Yamaha 8 hp out board. It is satisfactory and will push the 29 footer against about 25 knot winds (barely). To keep the prop in the water is the biggest trouble with this setup.
Forum: Diesel 05-05-2014
Replies: 43
Views: 2,153
Posted By Mechsmith
Re: Cleaning my Yanmar injectors?

Now you have them out I would prefer to take them to a diesel injection repair shop or read the test and spray proceedures from a shop manual. They are all more or less similar but a common problem...
Forum: General Discussion (sailing related) 04-30-2014
Replies: 75
Views: 5,843
Posted By Mechsmith
Re: Single handed anchoring questions

Or cleat it on the bow but lead the rode outside the lifelines and shrouds back prior to anchoring, then lower it from the cockpit whilst on a reach or run and wait for it to set and swing you...
Forum: Diesel 04-29-2014
Replies: 28
Views: 1,207
Posted By Mechsmith
Re: oh oh water pump

Just a little note on antifreeze.

Some brands are "pre mixed". You can run these at 100%. Some brands are essentially pure ethylene glycol with some additives. DO NOT run these at more than...
Forum: General Discussion (sailing related) 04-26-2014
Replies: 74
Views: 3,974
Posted By Mechsmith
Re: Why don't boats have headlights?

I set one up but the fog off the water made it worse than none at all. That was on the Calusahatchee River wanting to see daymarks into channel. Maybe a different color or polarizing would help but...
Forum: General Discussion (sailing related) 04-10-2014
Replies: 81
Views: 5,416
Posted By Mechsmith
Re: The run aground poll

Last time I had the keel off I installed a "sled runner" on the bottom of it. That probably tells you enough!
Forum: General Discussion (sailing related) 04-09-2014
Replies: 13
Views: 1,339
Posted By Mechsmith
Re: If you scuttle your boat, will insurance pay?

I only carried liability insurance. If you can't afford to lose your boat then it's irresponsible to expect somebody else to.
Forum: Diesel 03-27-2014
Replies: 6
Views: 652
Posted By Mechsmith
Re: 1gm10 low oil pressure after changing water pump

I'd bet on the oil pump inlet screen being clogged up.

Fryewe gave good advice
Forum: Engines 03-25-2014
Replies: 3
Views: 536
Posted By Mechsmith
Re: kh18 shift fork

No additional thoughts. That'll work, probably better than new.
Forum: Gear & Maintenance 03-24-2014
Replies: 26
Views: 7,789
Posted By Mechsmith
Re: Hatch lens replacement

I would try one of the headlight cleaning kits sold in auto parts stores for plastic headlights. They may do the job pretty well.
Forum: Diesel 03-24-2014
Replies: 4
Views: 643
Posted By Mechsmith
Re: Perkins 4-107 Overhaul

I feel like talkin. Hope you feel like readin.

First when you have an older motor lets see what you have as far as the hard parts are concerned.:(

Get the thing warmed up and take her out some....
Forum: Engines 03-20-2014
Replies: 3
Views: 536
Posted By Mechsmith
Re: kh18 shift fork

I have brazed up the wear pads on a couple of different forks. If its broken and brass (common) or broken and bronze you should be able to repair it.

Steel ones usually have plastic wear pads...
Forum: Vessels Lost, Missing, or in Danger 02-10-2014
Replies: 175
Views: 10,776
Posted By Mechsmith
Re: Bounty captain Robin Walbridge's 'reckless decision' blamed for sinking

If it was a movie prop why was it off shore? Was the captain or company informed that it was just a movie prop and never was intended to be sailed.

Yes a lot of poor judgement was shown but...
Forum: Vessels Lost, Missing, or in Danger 02-10-2014
Replies: 175
Views: 10,776
Posted By Mechsmith
Re: Bounty captain Robin Walbridge's 'reckless decision' blamed for sinking

Sorry, I would blame a lot of it on the builder.

Ships and boats are supposed to utilize wind and water. Short of hitting shallow water or failing to depower the sails there is a limit to what...
Forum: Outboard 02-06-2014
Replies: 7
Views: 557
Posted By Mechsmith
Re: Outguessing the Outboard

On my 7.5 hp Merc there is a warning not to let the wires touch each other. It'll take out the rectifier. The 6 amp alternator was on many smaller outboards. Kind of handy.
Forum: Gear & Maintenance 01-18-2014
Replies: 13
Views: 914
Posted By Mechsmith
Re: sewing sunbrella

I found a White "Jeans Machine" in a thrift shop for $25.It has all the power that you'll ever need short of doing it professionally. No walking foot though, and it would be better with one.
Forum: Florida - Western 01-16-2014
Replies: 11
Views: 997
Posted By Mechsmith
Re: vacation help... panama city fl to key west fl

One time through the Franklin Lock we were accompanied by a couple of manatees. They know exactly how the locks work. You'd see quite a few of them in winter near the electric plant near Ingles....
Showing results 1 to 25 of 168

 

All times are GMT -4. The time now is 08:34 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.