SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 9 of 9
Search took 0.01 seconds.
Search: Posts Made By: scratchee
Forum: Gear & Maintenance 1 Week Ago
Replies: 13
Views: 989
Posted By MarkSF
Re: What can/should I do while repacking my stuffing box?

I have the Teflon seal packing, and it is almost as good as the dripless. (I don't have clearance for a proper dripless).

I'd suggest replacing the hose as others have said, and use new hose...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 13
Views: 989
Posted By capta
Re: What can/should I do while repacking my stuffing box?

I would suggest you do an inspection of your cutlass bearing and replace if necessary. Also after insuring you have a good cutlass bearing and no packing in, I would do an engine alignment. You will...
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 13
Views: 989
Posted By jimrafford
Re: What can/should I do while repacking my stuffing box?

Replace the rubber hose of the stuffing box. Should be done every 8 years. I replaced mine last spring. Looked fine. Got it out and closer inspection revealed it was badly cracked.
Jim
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 13
Views: 989
Posted By casey1999
Re: What can/should I do while repacking my stuffing box?

Replace your cutlas bearing if it has any play-grab the prop and try to move it sideways and up and down. Anything more than 1/32 inch then replace. Also check condition of all thru hulls and...
Forum: General Discussion (sailing related) 10-05-2014
Replies: 51
Views: 2,538
Posted By TakeFive
Re: My crappy sail today

I understand, and it's clear that you need a longer line, or to unwrap the current line a bit on the drum.

But do note that that was not what caused the jam. It's the bottom layers of the wrap...
Forum: Gear & Maintenance 05-26-2014
Replies: 8
Views: 652
Posted By knuterikt
Re: Real world corrosion control for mast fittings

Some pictures from a boom that is 29 years old, have been used on saltwater all its life (the boom was replaced with a new one last summer)
The traces of Duralac is only one year old...
Forum: Gear & Maintenance 06-20-2013
Replies: 33
Views: 1,898
Posted By casey1999
Re: Mast work

This book will show you what you need to do to climb your mast without much cost (go to section 6-4 for mast climbing):
Singlehanded Tips Book (http://sfbaysss.org/tipsbook/)
Forum: Chesapeake Bay 06-18-2013
Replies: 40
Views: 2,040
Posted By travlineasy
Re: Rock Hall gouge?

I've been to Rock Hall dozens of times over the past couple years, but not because it was a great place to visit. Waterman's Restaurant was OK, but that's about as high as I would rate it. I...
Forum: General Discussion (sailing related) 01-11-2013
Replies: 96
Views: 20,608
Posted By miatapaul
Re: Latts & Atts is GONE!

Well the magazine was started by Bob Bitchin, aka Robert Lipkin. The magazine was bought out by "sextant publishing" headed by a DJ Doran.

a .1 second Google search resulted in the following, the...
Showing results 1 to 9 of 9

 

All times are GMT -4. The time now is 05:32 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.