SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Chat  
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 10 of 10
Search took 0.01 seconds.
Search: Posts Made By: JUST MESSIN WITH IT
Forum: North American Yachts 06-02-2012
Replies: 26
Views: 3,018
Re: swing keel problem

Hey Thanks for the pictures guys, a couple of questions.

Is the 47 inches the finished length or the before repair length.

What would be the finished length

Assuming a circlular section at...
Forum: North American Yachts 05-26-2012
Replies: 26
Views: 3,018
Re: swing keel problem

I dont suppose you could measure the part of keel you have , im goin to have to make one sooner or later. Does the keel pin hole have a plastic bush ? how thick is it at keel pin hole? what should...
Forum: North American Yachts 05-05-2012
Replies: 26
Views: 3,018
Re: swing keel problem

Had a complete disaster today. Much the same as you had.
I have been renovating the interior of my boat , and itching to get it in the water. Finally today i was ready for launch...or so i...
Forum: North American Yachts 04-27-2012
Replies: 50
Views: 4,870
Re: Spirit 23 modifications

I have just ripped out the headlining as it had holes all over the place and scruffy marks. Found lots of the deck hardware bolts were loose and letting water in. After tighenening everything up i...
Forum: North American Yachts 04-17-2012
Replies: 10
Views: 1,496
Re: standing rigging

im no expert ....but..........surely if one side is over tight and the other is over lose , the mast must be leaning slightly. slacken off the tight side and tighten up the loose side ...

does...
Forum: North American Yachts 04-17-2012
Replies: 6
Views: 1,077
Re: Bimini top

Well i managed to get the bimini up . Had to reduce the height by about 4 inches to make it fit properly.

Not sure i have it in the same palce as others ive seen , but it sure makes it awkward...
Forum: North American Yachts 04-17-2012
Replies: 6
Views: 1,077
Re: Bimini top

eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices (http://www.ebay.com/itm/310393568529?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649)

thanks a...
Forum: North American Yachts 04-15-2012
Replies: 6
Views: 1,077
Re: Bimini top

I ended up putting the mast and boom up in the back yard. If i sit it on the high part of the cockpit side its 40 inches , if i go to the outer its 44 inches. I nended up buying a 46 inch high by 98...
Forum: North American Yachts 04-12-2012
Replies: 10
Views: 1,294
Re: newbie seeks advice

I have managed to get the mast up on my own without too much hassle.
I have a wooden crutch ( 6' 6" long with a v cut at the top). With the mast laying on the fore deck i raise the crutch with the...
Forum: North American Yachts 04-11-2012
Replies: 6
Views: 1,077
Bimini top

I am prepping the boat for the redneck yacht club party in two weeks.
I would like to fit a bimini top. I can see from pictures where others have successfully fitted them. Im thinking width wise...
Showing results 1 to 10 of 10

 

All times are GMT -4. The time now is 07:03 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.