SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 6 of 6
Search took 0.01 seconds.
Search: Posts Made By: Ham1sh
Forum: Gear & Maintenance 04-20-2010
Replies: 2
Views: 1,303
Posted By Ham1sh
I believe it is a Seidelmann 295. No photographs...

I believe it is a Seidelmann 295. No photographs at this time. The cavity is oval-shaped, about 1 inch deep, 8 inches long and 4 inches wide. This is not a hole, but an formed indent in the hull,...
Forum: Gear & Maintenance 04-20-2010
Replies: 2
Views: 1,303
Posted By Ham1sh
Seidelmann prop-shaft through hull

My friend discovered a soft spot and some water drips just forward of where his prop shaft exits the hull. He excavated the area and discovered an area of fibreglass filler covered with some marine...
Forum: Gear & Maintenance 11-17-2008
Replies: 19
Views: 1,502
Posted By Ham1sh
At the risk of being overly simple, I suggest...

At the risk of being overly simple, I suggest that the second through-hull is to drain galley sink water. It is on my boat.
Forum: Gear & Maintenance 10-17-2008
Replies: 6
Views: 1,501
Posted By Ham1sh
I wood first try mixing some of the teak sawdust...

I wood first try mixing some of the teak sawdust with carpenter's glue and filling the gouges. When cured, sand and varnish as normal. If the gouges are limited to close to the plugs, you could drill...
Forum: Gear & Maintenance 09-14-2008
Replies: 29
Views: 2,206
Posted By Ham1sh
I replaced my old head hoses with reinforced...

I replaced my old head hoses with reinforced sanitary hose. I tried for ages to fit the hose onto the plastic fittings - to no avail. I then discovered that the "ribbed" fittings were incompatible...
Forum: Gear & Maintenance 06-19-2007
Replies: 14
Views: 10,843
Posted By Ham1sh
I recently had what appeared to be similar...

I recently had what appeared to be similar starter problems with my Yanmar 2GM20F. There are hundreds, if not thousands of pages on the internet offering advice for this problem, ranging from total...
Showing results 1 to 6 of 6

 

All times are GMT -4. The time now is 01:01 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.