SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 27
Search took 0.01 seconds.
Search: Posts Made By: capt jgwinks
Forum: Diesel 05-11-2014
Replies: 10
Views: 469
Posted By capt jgwinks
The good news about any Universal diesel is that...

The good news about any Universal diesel is that it's really a Kubota and most parts can be had dirt cheap from a tractor shop. The only ones you can't get there are the exhaust manifold, bell...
Forum: Gear & Maintenance 04-05-2014
Replies: 25
Views: 1,543
Posted By capt jgwinks
Re: How much paint will I need to do the bottom of a 30 footer

Never been able to figure that one out myself. My 36 Columbia should take a gallon or more, but I get decent coverage with 2 quarts. Your supposed to put on 2 coats which would almost be the amount...
Forum: Gear & Maintenance 03-22-2014
Replies: 16
Views: 1,045
Posted By capt jgwinks
Re: Need a creative solution

Add extensions. Get some tubing the same size as your frame, and a couple of feet one size smaller. Slide the smaller tube inside the larger to form a spline and lock them together with screws or pop...
Forum: General Discussion (sailing related) 03-21-2014
Replies: 7
Views: 610
Posted By capt jgwinks
Re: TV Antenna

Don't know if its the same unit, but when I worked at West Marine about 10 years ago we had one called the UFO, and I think every one we sold got returned. Customers said they didn't work at all....
Forum: Gear & Maintenance 03-08-2014
Replies: 13
Views: 769
Posted By capt jgwinks
I've never sprayed one, but have done a number by...

I've never sprayed one, but have done a number by roll and tip. If your experience is doing cars, there won't be much difference. If your used to doing houses, you'll have to pay a lot more attention...
Forum: Gear & Maintenance 03-01-2014
Replies: 13
Views: 856
Posted By capt jgwinks
To find a good spot for a shoot through, hold the...

To find a good spot for a shoot through, hold the ducer against the hull with a baggie full of water in between. (Boat has to be in the water). Once you find a good spot where it works, glue it down...
Forum: General Discussion (sailing related) 02-12-2014
Replies: 30
Views: 1,739
Posted By capt jgwinks
re: USCG 6 Pack License

I have been teaching the OUPV and Master courses for over 10 years. In my experience it is well worth the tuition to take a USCG approved course as the test is then given by the school, not the CG....
Forum: Diesel 02-01-2014
Replies: 44
Views: 3,646
Posted By capt jgwinks
I believe the injectors,as well as many other...

I believe the injectors,as well as many other parts are generic with many of the smaller Kubota engines.
The Y850 was never used in a tractor, apparently built just for Universal. You're pretty...
Forum: Boat Review and Purchase Forum 01-11-2014
Replies: 11
Views: 694
Posted By capt jgwinks
A large percentage of boat fires are caused by...

A large percentage of boat fires are caused by pressure alcohol stoves. If a propane stove is properly installed with a gas sniffer alarm/shutoff, it is much safer. Used to be USCG didn't allow...
Forum: Gear & Maintenance 01-09-2014
Replies: 15
Views: 516
Posted By capt jgwinks
Any marine store (West Marine, etc) will have...

Any marine store (West Marine, etc) will have them in stock our to order. In a pinch as emergency replacement, you can cut a hardware store wooden yardstick to length. Back in the old days we always...
Forum: Gear & Maintenance 01-09-2014
Replies: 16
Views: 954
Posted By capt jgwinks
Tie down points for a cover or something?

Tie down points for a cover or something?
Forum: Electronics 01-08-2014
Replies: 7
Views: 287
Posted By capt jgwinks
Your tablet should have GPS built in unless it's...

Your tablet should have GPS built in unless it's an absolute cheapo. There are several good plotter apps available in the play store, I use Marine Navigator Lite on my phone, it works well and uses...
Forum: Diesel 01-08-2014
Replies: 7
Views: 290
Posted By capt jgwinks
I always look on E bay first. Needed injector...

I always look on E bay first. Needed injector nozzles for the 5411as well, found brand new replacements there for $45 each inc shipping, local Kubota dealer was $71, Torreson wanted $401. Had the...
Forum: Diesel 01-07-2014
Replies: 7
Views: 290
Posted By capt jgwinks
I just had the injection pump on My Universal...

I just had the injection pump on My Universal 5411 (Kubota Z500) rebuilt at a local diesel injection shop. Cost was $198, the cheapest replacement could find online from tractor shops was $433 plus...
Forum: Electronics 12-24-2013
Replies: 10
Views: 674
Posted By capt jgwinks
Were you plugged into shore power at the time?...

Were you plugged into shore power at the time? That will often put a loud 60 hertz hum into the signal.
Forum: Diesel 12-23-2013
Replies: 16
Views: 1,037
Posted By capt jgwinks
Most shifters can be reversed. The arm that...

Most shifters can be reversed. The arm that pushes/pulls the cable can be taken off and put on the other way.
I think you could check the difference in gear ratios by running the engine while...
Forum: Diesel 12-20-2013
Replies: 5
Views: 1,053
Posted By capt jgwinks
I know this is an old thread, but for anyone...

I know this is an old thread, but for anyone reading, yes it is the crankshaft, and yes the tractor can have a pto attached there. There are two other shafts on the engine but they turn 1/2 of crank...
Forum: Gear & Maintenance 12-20-2013
Replies: 9
Views: 428
Posted By capt jgwinks
Ive got the same brown goo oozing from a couple...

Ive got the same brown goo oozing from a couple of places under the deck of my 1969 Columbia 36. Its not rust, I think its color leaching out of the balsa core and/or polyester resin. If you take the...
Forum: Gear & Maintenance 12-19-2013
Replies: 5
Views: 472
Posted By capt jgwinks
If you must pull the rudder head off in the...

If you must pull the rudder head off in the water, first c check if theres a clamp or something to keep it from dropping out. Even if there is one out might not take the weight impacting it. You...
Forum: General Discussion (sailing related) 12-15-2013
Replies: 50
Views: 4,733
Posted By capt jgwinks
Another thing to consider for mooring a boat for...

Another thing to consider for mooring a boat for any length of time, even just a few days, is how do you get off the boat? You have to land your dinghy somewhere without getting popped for...
Forum: Boat Review and Purchase Forum 12-15-2013
Replies: 100
Views: 5,031
Posted By capt jgwinks
One survey experience I had: Hired a very...

One survey experience I had: Hired a very reputable and well recommended guy to look over a prospective purchase (in November in Michigan). Survey was done as scheduled and I picked up two copies of...
Forum: Pacific Seacraft 12-14-2013
Replies: 5
Views: 483
Posted By capt jgwinks
Have you looked at Lowes or Menards, etc? Might...

Have you looked at Lowes or Menards, etc? Might find a smaller bar sink thats just as nice for a heck of a lot cheaper. Same thing for the faucet.
Forum: Gear & Maintenance 12-14-2013
Replies: 17
Views: 978
Posted By capt jgwinks
Hopefully the line is labeled a to what it's made...

Hopefully the line is labeled a to what it's made of. You'll want dacron, but not nylon or poly propylene. Nylon is too stretchy, poly has no UV resistance. Other than that, the hardware store stuff...
Forum: Diesel 12-11-2013
Replies: 7
Views: 1,256
Posted By capt jgwinks
Replied more for anyone else with a similar...

Replied more for anyone else with a similar problem.
Forum: Diesel 12-08-2013
Replies: 7
Views: 1,256
Posted By capt jgwinks
Re: looking for universal m-18 engine

If you find that the M18 can't be resonably repaired, here's a option that may work. The M18 is really a Kubota Z600 engine. Go to dieselenginetrader.com or a similar site and see if you can find...
Showing results 1 to 25 of 27

 

All times are GMT -4. The time now is 06:07 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.