SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 15 of 15
Search took 0.01 seconds.
Search: Posts Made By: admin
Forum: Gear & Maintenance 02-03-2006
Replies: 2
Views: 979
Posted By admin
Dinghy Bottom Growth

You are discovering why I switched from an inflatable to a hard dink (with antifouling on the bottom).

I tried most of the antifouling paints that are marketed for inflatables with no success. ...
Forum: Gear & Maintenance 02-02-2006
Replies: 28
Views: 3,197
Posted By admin
up the mast on the hard

chefmango
Please read the entire thread, OK? I suggested earlier that on the hard you run lines from the top of the mast to four points on the ground. If this will keep a boat from blowing over...
Forum: Gear & Maintenance 02-01-2006
Replies: 28
Views: 3,197
Posted By admin
up the mast on the hard

It''s magic.

Just check out this site:
http://www.andamanseapilot.com

Terry
Forum: Gear & Maintenance 01-31-2006
Replies: 28
Views: 3,197
Posted By admin
up the mast on the hard

Irwin32,

Be glad to do it and I''ll have the rum first, please!

Only catch is that you have to bring the boat to Phuket, Thailand.

Cheers,
Terry
Forum: Gear & Maintenance 01-31-2006
Replies: 5
Views: 5,972
Posted By admin
Sewing Machine for Canvas Work

For using a home machine to do sail and canvas work, go to http://yachtvalhalla.net/downloads/download.htm
and download the article ''Repair your own sails'' by Jim Grant of Sailrite. The article...
Forum: Gear & Maintenance 01-27-2006
Replies: 28
Views: 3,197
Posted By admin
up the mast on the hard

Remember the line from Jimmy Buffet .. "Don''t try to describe a KISS concert if you''ve never seen one".

Those faint hearted souls who won''t climb a mast are missing out on an exciting part of...
Forum: Seamanship & Navigation 01-27-2006
Replies: 4
Views: 1,269
Posted By admin
GPS causes electrical

Does this happen when you have a program interfacing with the GPS?

The GPS produces an RF output from it''s internal oscillator and if the input isn''t connected to a program when it''s turned on...
Forum: Seamanship & Navigation 01-27-2006
Replies: 13
Views: 6,812
Posted By admin
tow dingy with outboard?

DON''T RISK THAT EXPENSIVE ENGINE!

I have towed both inflatables and hard dinghys. I have a 32 foot ketch so removing a 15HP engine was never a problem .. the mizzen boom was used to transfer the...
Forum: Gear & Maintenance 01-26-2006
Replies: 3
Views: 972
Posted By admin
Seaview radar mast mount

Neicy,

I''ve installed a Furuno radar on my mizzen mast but the same would apply to any mast, I guess.

I used a spare halyard to hold the mount at the location I wanted and a couple of bar...
Forum: Gear & Maintenance 01-25-2006
Replies: 12
Views: 1,236
Posted By admin
wood renewal

Here''s a good site also:

http://www.anzam.com/howto_index_001.htm

Terry
Forum: Gear & Maintenance 01-25-2006
Replies: 12
Views: 1,236
Posted By admin
wood renewal

Like many other cruisers, I keep the sole covered with indoor-outdoor carpet. A varnished cabin sole is TOO DANGEROUS when underway in any moderate seaway, especially when it gets wet. And it WILL...
Forum: Gear & Maintenance 01-25-2006
Replies: 28
Views: 3,197
Posted By admin
up the mast on the hard

I''d say a lot depends on how securely the jack stands are under the boat. But I''ve done it many time with my boat on the hard AFTER running lines from the top of the mast in four directions to...
Forum: General Discussion (sailing related) 01-21-2006
Replies: 12
Views: 1,532
Posted By admin
Propane locker problems

Hi, Jack - Guess I''ve been lucky the past 26 years? When I originally installed my propane system the only convenient location for the tank was in the cockpit below the wheel. I have a relatively...
Forum: General Discussion (sailing related) 01-20-2006
Replies: 12
Views: 1,532
Posted By admin
Propane locker problems

Why is venting to the cockpit not acceptable?

Terry
Forum: Gear & Maintenance 01-20-2006
Replies: 2
Views: 903
Posted By admin
AIS (Automatic Identification System)

I have recently installed an AIS listener and PC display capability. Details at http://yachtvalhalla.net/projects/ais/ais.htm

Would appreciate comments from others who may have AIS or want to...
Showing results 1 to 15 of 15

 

All times are GMT -4. The time now is 10:52 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012