SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 69
Search took 0.01 seconds.
Search: Posts Made By: rheaton
Forum: Gear & Maintenance 05-12-2009
Replies: 8
Views: 2,674
Posted By rheaton
My strainer is not like that one. Mine is...

My strainer is not like that one.

Mine is rectangle shaped. It's about 6" long and 3" wide, 1.5" deep at aft end, and 1" deep towards bow. Many holes about 1mm forming the strainer. I will take...
Forum: Gear & Maintenance 05-11-2009
Replies: 8
Views: 2,674
Posted By rheaton
Folks, I know this is an old thread but, I have a...

Folks, I know this is an old thread but, I have a question along the same line, which I don think was answered here. I have a 1978 Catalina 30. It has a strainer type thru hull fitting. It is a...
Forum: Gear & Maintenance 01-09-2009
Replies: 19
Views: 5,773
Posted By rheaton
I could use some for patching my old sail. May I...

I could use some for patching my old sail. May I ask where you are located.
Forum: General Discussion (sailing related) 10-28-2008
Replies: 26
Views: 1,092
Posted By rheaton
I'm 47. Sail a Catalina 30 on the Hudson. Young...

I'm 47. Sail a Catalina 30 on the Hudson. Young compared to most of the old folks in my club. Russ
Forum: Gear & Maintenance 10-16-2008
Replies: 11
Views: 1,140
Posted By rheaton
Try Viking Boat Yard, Verplank, NY, on the...

Try Viking Boat Yard, Verplank, NY, on the Hudson. $33/ft.
Forum: General Discussion (sailing related) 09-24-2008
Replies: 20
Views: 1,378
Posted By rheaton
Buy new flares and keep old one as spares.

Buy new flares and keep old one as spares.
Forum: Gear & Maintenance 09-24-2008
Replies: 10
Views: 1,258
Posted By rheaton
Check this out Boat Maintenance and...

Check this out

Boat Maintenance and Repairs: Dealing With Leaks (http://www.yachtsurvey.com/dealing_with_leaks.htm)
Forum: Gear & Maintenance 06-12-2008
Replies: 36
Views: 4,707
Posted By rheaton
A good place to get this would be a RV / camper...

A good place to get this would be a RV / camper store. They use it to seal their windows.
Forum: Gear & Maintenance 06-10-2008
Replies: 20
Views: 5,035
Posted By rheaton
Have you tried soaking your thermostat in viniger...

Have you tried soaking your thermostat in viniger overnight. This can clean them nicely. I have the moyer manual. It describes this there. If you need anything looked up in the manual, let me know.
Forum: Gear & Maintenance 06-09-2008
Replies: 12
Views: 951
Posted By rheaton
You might consider fabricating the piece our of...

You might consider fabricating the piece our of fiberglass and epoxy. machine this piece to fit then use 5200 to attach it. This would be strong and would not rot or corrode. I saw this described for...
Forum: Gear & Maintenance 06-09-2008
Replies: 25
Views: 4,261
Posted By rheaton
Found a nice way to make this a one man job. Use...

Found a nice way to make this a one man job. Use a hack saw to cut a notch into a nut of the same size as the one on your bolt. From below put this nut onto the bolt and clamp it with vise grips....
Forum: Gear & Maintenance 06-09-2008
Replies: 14
Views: 1,412
Posted By rheaton
check your circuit panel. mine has switches for...

check your circuit panel. mine has switches for master, and a switch for each circuit. perhaps you have master or one of the others off.
Forum: General Discussion (sailing related) 06-03-2008
Replies: 12
Views: 1,039
Posted By rheaton
I have a calander which has a picture of a ship...

I have a calander which has a picture of a ship which looks like this. It was named there Atlantic, 1916.
Forum: General Discussion (sailing related) 05-22-2008
Replies: 4
Views: 5,402
Posted By rheaton
I could recommend the Hook Mountain Yacht Club,...

I could recommend the Hook Mountain Yacht Club, located at Nyack , NY, on the Hudson. Our url is Hook Mountain Yacht Club (http://hmyc.net/). We offer one-day free transient moorings. Additional days...
Forum: Gear & Maintenance 05-09-2008
Replies: 9
Views: 2,033
Posted By rheaton
I recently purchased new halyard line and sheaves...

I recently purchased new halyard line and sheaves for my catalina 30 from catalina direct. Their techincal hotline folks will give you good advice. I also bought a fid set and, after a number of...
Forum: General Discussion (sailing related) 05-05-2008
Replies: 17
Views: 1,674
Posted By rheaton
Did you check the on/off value on your fuel...

Did you check the on/off value on your fuel supply.
Forum: Gear & Maintenance 05-02-2008
Replies: 6
Views: 2,645
Posted By rheaton
On my boat there is a pin secured by a ring clip...

On my boat there is a pin secured by a ring clip which must be removed before the speen indicator can be pulled from it's housing. After removing this pin I was able to remove the unit and quickly...
Forum: Gear & Maintenance 04-29-2008
Replies: 4
Views: 1,368
Posted By rheaton
What can be done to mitigate risk of fire. This...

What can be done to mitigate risk of fire. This is a gasoline engine. Would running a fan suffice.
Forum: herSailNet 04-28-2008
Replies: 40
Views: 5,908
Posted By rheaton
A wise man once gave me advice on marrage. He...

A wise man once gave me advice on marrage. He said "do you want to be right, or do you want to be happy".
Forum: Learning to Sail 04-23-2008
Replies: 73
Views: 8,474
Posted By rheaton
Go to google and enter heaving to. You will see a...

Go to google and enter heaving to. You will see a number of items describing it, and some videos.
Forum: Gear & Maintenance 04-14-2008
Replies: 14
Views: 3,407
Posted By rheaton
Thanks folks for the links. I had thought about...

Thanks folks for the links. I had thought about repairing it. I bought the epoxy and glass. Then I looked at the rudder again and decided on replacing it. There is a crack two foot on both sides of...
Forum: Gear & Maintenance 04-14-2008
Replies: 14
Views: 3,407
Posted By rheaton
Folks, again thanks for your input. After looking...

Folks, again thanks for your input. After looking again at the rudder, I have decided to replace. Does any one have a descrition of the steps involved with the repacement. I thought I had seen some...
Forum: Provisioning 04-02-2008
Replies: 18
Views: 2,132
Posted By rheaton
You might want to think about looking into...

You might want to think about looking into getting a small butane stove. These are in expensive and can be found at asian markets amoung other places. This would allow you to prepare foods, tea, and...
Forum: Boat Review and Purchase Forum 03-24-2008
Replies: 10
Views: 1,398
Posted By rheaton
You might also ask your insurance company if they...

You might also ask your insurance company if they recommend surveyors. Mine had a list of accepted, and not acepted ones.
Forum: Learning to Sail 03-24-2008
Replies: 43
Views: 8,904
Posted By rheaton
A wise old salt once told me. "your main sheet is...

A wise old salt once told me. "your main sheet is your best friend"
Showing results 1 to 25 of 69

 

All times are GMT -4. The time now is 12:11 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.