SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Chat  
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 182
Search took 0.05 seconds.
Search: Posts Made By: redline
Forum: Gear & Maintenance 2 Weeks Ago
Replies: 26
Views: 1,490
Posted By redline
Re: 30 Year Old Propane Stove

Interesting, though right now I have two 400-pound un-buried propane tanks which are doing a fine job of feeding the stove and two gas furnaces (the discerning reader will have concluded that I am...
Forum: Electrical Systems 12-04-2014
Replies: 42
Views: 3,974
Posted By redline
Re: Xantrex AC hook up??

Re the "three-pole breaker" - my prev C&C had what looked like a 3-pole, but was actually three sections: a double-pole 30A breaker joined with a 50(ish) VOLT section wired between neutral and...
Forum: Gear & Maintenance 12-04-2014
Replies: 26
Views: 1,490
Posted By redline
Re: 30 Year Old Propane Stove

Make sure it's actually a propane, and not butane, stove. Many European boats use butane, in fact my Jeanneau factory manuals refer to the butane system which was decommissioned/replaced with propane...
Forum: Gear & Maintenance 12-03-2014
Replies: 10
Views: 567
Posted By redline
Re: Fuel tank repair

Re "I did fill the tank with water after the repair, no leaks.", a friend had his water separator break (hint, drain the water before temps go below freezing) and gravity-feed much of his diesel tank...
Forum: Pacific Seacraft 11-29-2014
Replies: 15
Views: 1,194
Posted By redline
Re: Snubber thoughts

My snubber is a fairly large length of old mooring line (also served as splicing practice), not especially stretchy but it's main purpose is to take the load off the windlass, and secondly to avoid...
Forum: Gear & Maintenance 11-22-2014
Replies: 11
Views: 744
Posted By redline
Re: Foot switches for an Anchor Windlass

Our ba
Our boat came with foot separate switches at the aft corners of the anchor well; effective but necessitating doing the splits to see the anchor break surface while stepping on the switch. We...
Forum: Gear & Maintenance 10-29-2014
Replies: 14
Views: 1,798
Posted By redline
Re: Replace springs on outboard lifting bracket??

When I upgraded to a 15HP Honda I added a small 4:1 block arrangement up to the stern rail. Made lifting the 104 lb (!) motor easy, even though it involved pulling the rope the entire length of the...
Forum: Gear & Maintenance 10-16-2014
Replies: 12
Views: 690
Posted By redline
Re: Installing a SSB with a Questas gimballed radar mount

Even with an insulator above the radar, the GtO feed line running up to the insulator is part of the antenna anyway. Have you considered a wire antenna on a separate halyard? I put my tuner up on...
Forum: Electronics 08-22-2014
Replies: 8
Views: 414
Posted By redline
Re: RS-232 to Bluetooth Converters

TakeFive, I use Sailtracker V2.1r31 (free). It displays lat/lon, COG, SOG, Relative and True Wind (as numbers and a dial), waypoint info (bearing, dist), even depth on a graph and a Polar plot (which...
Forum: Electronics 08-22-2014
Replies: 8
Views: 414
Posted By redline
Re: RS-232 to Bluetooth Converters

I've used a Parani10 from Sena. Takes an NMEA feed from a Raymarine Seatalk-to-NMEA converter for a laptop, and more recently, an Android tablet. It works fine though I don't use it much, mostly just...
Forum: Electronics 07-19-2014
Replies: 10
Views: 570
Posted By redline
Re: 12v voltage regulator

I bought a Carnetix DC-DC converter meant for car computers; gives a nice 12v (and 5v) well regulated. Not using it just now; my hair TV seems happy on ship's "12v".


Sent from my iPad using...
Forum: Electrical Systems 07-13-2014
Replies: 23
Views: 1,353
Posted By redline
Re: Electrical Upgrades

I'll admit to having installed LED replacement bulbs in my nav fixtures, though not for the lower drain but for longer life - even though I rarely sailed at night, the original bulbs with their long...
Forum: Electrical Systems 06-27-2014
Replies: 5
Views: 528
Posted By redline
Re: Proposed wiring diagram for a trailer sailer

One suggestion for the assignment of breakers on your panel: one boat we chartered on had all the "at sea" loads in a row on one side of the panel, and the "anchored/docked" loads on another. Made it...
Forum: Electronics 06-26-2014
Replies: 42
Views: 2,729
Posted By redline
Re: Airmar / Raymarine DST800 Transducer Issue

The height of the geyser will depend on how far under water the fitting is. I pull mine to haul and launch (sling straps are bad for the wheel) and there's a gush, but I either clap my hand on it or...
Forum: Gear & Maintenance 06-10-2014
Replies: 15
Views: 833
Posted By redline
Re: Key switch

The purpose of the ball bearing is to keep the key from falling out or being removed in the ON position. When mine fell apart I used the compass light switch for a while until I got a replacement...
Forum: Diesel 06-10-2014
Replies: 4
Views: 670
Posted By redline
Re: Transmission Yanmar KM35P problem

I had that negative experience - "lapping" initially "fixed" the problem, but only for about one season... Then it came back. Even worse, the marine lapped it a second time, which lasted even less. ...
Forum: Diesel 06-05-2014
Replies: 4
Views: 670
Posted By redline
Re: Transmission Yanmar KM35P problem

If that is a cone clutch tranny, it sounds like the cone is worn. My 2GM20 had that problem (don't recall which transmission it had; your number sounds familiar, though yours is likely bigger but may...
Forum: Gear & Maintenance 06-05-2014
Replies: 4
Views: 415
Posted By redline
Re: Need help removing these icebox lids

Is that round piece a cap/plug covering a screw? Have you tried to pry it out?


Sent from my iPad using Tapatalk
Forum: Gear & Maintenance 05-31-2014
Replies: 49
Views: 3,360
Posted By redline
Re: Red over Green Navigation Light

I thought about installing red-over-green on my boat; my research found that Lopolight make 180 degree green sp in theory an all-round red at the top with a green on each side of the mast 1 m down...
Forum: Gear & Maintenance 05-29-2014
Replies: 25
Views: 1,220
Posted By redline
Re: Bird nests in the boom

We use a crumpled wad of aluminum foil in the end of the boom. There's a plastic cap, but still an opening around it. Birds don't peck out the foil.


Sent from my iPad using Tapatalk
Forum: Gear & Maintenance 05-13-2014
Replies: 1
Views: 285
Posted By redline
Re: Need an IPN ProRemote for 20 minutes

Where? If you're in Montreal (or at least north of the 49th), we can talk.
Would an IPM UCM (Ethernet comm module) do the job?



Sent from my iPad using Tapatalk
Forum: Gear & Maintenance 04-27-2014
Replies: 5
Views: 548
Posted By redline
Re: ST60 wind display

You can swap the housing. I replaced an ST60 Winfd with an ST60+ wind and installed the new + in the old 69 housing. Looks like the other five, only the + on the dial shows the difference. And...
Forum: Electronics 04-18-2014
Replies: 73
Views: 2,651
Posted By redline
Re: Entry level AIS?

The Standard GX2150 VHF with AIS does output both DSC and AIS in NMEA0183. Icom also has a VHF/AIS combo which outputs AIS.


Sent from my iPad using Tapatalk
Forum: Diesel 04-15-2014
Replies: 47
Views: 2,819
Posted By redline
Re: Yanmar super vibration

Glad to have helped.

The 2GM20 had a single double-ended cone (I still have my old one), although I'd call it more than a "washer" - it weighs about a pound, the inside hole is a spiral thread...
Forum: Electrical Systems 04-14-2014
Replies: 5
Views: 513
Posted By redline
Re: Battery Help

Don't knock autocorrect - that's the only reason I ever get called Normal.

Norman



Sent from my iPad using Tapatalk
Showing results 1 to 25 of 182

 

All times are GMT -4. The time now is 11:32 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.