SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 166
Search took 0.03 seconds.
Search: Posts Made By: wsmurdoch
Forum: Pacific Seacraft 9 Hours Ago
Replies: 13
Views: 542
Posted By wsmurdoch
Re: Crealock 37 dinghy recommendations, anyone?

Marc,

Thanks. I think I'll give the outdoor carpet a try.

[My patched air floor (with two part glue and a seven day cure) seems to be holding air after a week. One part glue after 24 hr...
Forum: Pacific Seacraft 5 Days Ago
Replies: 13
Views: 542
Posted By wsmurdoch
Re: Crealock 37 dinghy recommendations, anyone?

We have a 8hp 2 stroke Nissan (Tohatsu) on our LSI 290. It will plane my wife, me, 3 gal of gas, and a few bags of groceries. Hauling fuel or water, it will not plane. We also have a 3.5 Tohatsu 2...
Forum: Pacific Seacraft 5 Days Ago
Replies: 13
Views: 542
Posted By wsmurdoch
Re: Crealock 37 dinghy recommendations, anyone?

Tell me about the protective carpet cover for the air floor. I have a LSI 290 that we have taken to the Bahamas twice. This year it was punctured by sandspurs stuck in the bottom of a shoe and...
Forum: Pacific Seacraft 3 Weeks Ago
Replies: 16
Views: 721
Posted By wsmurdoch
Re: Another RF ground ??

Your boat may have a copper HF radio ground strap built into the boat. See the older thread:

http://www.sailnet.com/forums/pacific-seacraft/103185-grounding-ssb-radio-psc-34-a.html

Bill...
Forum: Pacific Seacraft 4 Weeks Ago
Replies: 9
Views: 723
Posted By wsmurdoch
Re: cabin sole

My cabin sole is teak and holly veneer plywood. (I can see the plywood joint at the nav table / galley sinks.) A previous owner had sanded through the veneer in a couple of places exposing the base...
Forum: Pacific Seacraft 07-10-2014
Replies: 4
Views: 416
Posted By wsmurdoch
Re: Hot water problem

On my 3HM35F the fresh water coolant supply and return hoses supplying the coil in the water heater are connected to the inlet and the outlet of the engine fresh water coolant pump. Water should...
Forum: Pacific Seacraft 07-06-2014
Replies: 14
Views: 772
Posted By wsmurdoch
Re: PS 37 boarding ladder size

We also have a Tops in Quality boarding ladder. I just went looking for their web site

White Water Marine (http://www.topsinquality.com)

but it now brings me to White Water Marine. There I...
Forum: Pacific Seacraft 07-03-2014
Replies: 15
Views: 986
Posted By wsmurdoch
Re: PSC 37 staysail sheet rigging options?

Staysail dimensinons are in an earlier posting. (Google is your friend.)

http://www.sailnet.com/forums/pacific-seacraft/45827-staysail-measurements-37-a.html

Bill Murdoch
Forum: Pacific Seacraft 06-26-2014
Replies: 5
Views: 441
Posted By wsmurdoch
Re: Water/Holding Tank Lids

My two water tanks with PVC lids have not leaked during my ten year ownership of Irish Eyes. I routinely fill them until water stands in the fill pipes and on occasion loosen the inspection ports to...
Forum: Pacific Seacraft 06-24-2014
Replies: 2
Views: 287
Posted By wsmurdoch
Re: Group 24 fit my 34' PSC battery compartment?

Check out the older thread.

http://www.sailnet.com/forums/pacific-seacraft/102347-stow-location-batteries-psc-34-a.html

Bill Murdoch
Forum: Pacific Seacraft 06-22-2014
Replies: 5
Views: 441
Posted By wsmurdoch
Re: Water/Holding Tank Lids

My water tank lids were PVC, but the holding tank lid was plywood with fiberglass on the inside surface. I replaced the holding tank lid with 1/2" gray PVC from McMaster Carr. I then used the PVC...
Forum: Pacific Seacraft 06-20-2014
Replies: 6
Views: 489
Posted By wsmurdoch
Re: Red / Green Running Light Wiring

It’s done. The new wire (10 ft, 14 ga, 2 strand) is in the bow pulpit. Everything is finished.

You all were right. There was a big blob of caulking where the old wire left the forward starboard...
Forum: Pacific Seacraft 06-17-2014
Replies: 19
Views: 1,113
Posted By wsmurdoch
Re: Crealock-34 head

You might want to read

http://www.sailnet.com/forums/pacific-seacraft/75077-your-head-screwed-straight.html

Bill Murdoch
1988 PSC 34
Irish Eyes
Forum: Pacific Seacraft 06-15-2014
Replies: 12
Views: 723
Posted By wsmurdoch
Re: Cathunk, gurgle, swoosh

Same thing here. I have removed the cockpit floor to check that the engine (Yanmar 3HM35F) is not moving aft on its soft mounts, but I saw nothing interesting. I thought about going over the side...
Forum: Pacific Seacraft 06-09-2014
Replies: 6
Views: 489
Posted By wsmurdoch
Red / Green Running Light Wiring

Coming from Green Turtle Cay to St Augustine my wife woke me up in the middle of the night to say that the forward running light had gone out. It had a LED bulb in it, but not a problem as I had two...
Forum: Pacific Seacraft 06-06-2014
Replies: 4
Views: 432
Posted By wsmurdoch
Re: Anyone do a soundproofing kit on a PSC?

You might want to take a look at an earlier thread.

http://www.sailnet.com/forums/pacific-seacraft/72858-soundproofing-ps-engine-compartment.html

Bill Murdoch
Forum: Pacific Seacraft 06-01-2014
Replies: 15
Views: 986
Posted By wsmurdoch
Re: PSC 37 staysail sheet rigging options?

There is a jpeg of the PSC 37 Rigging Guide in a thread at the other Pacific Seacraft forum. It might be of use to you.

pacificseacraftowners.org ? View topic - Documents and Data Thread...
Forum: Pacific Seacraft 05-31-2014
Replies: 9
Views: 563
Posted By wsmurdoch
Re: Sheets for a PSC 34 V berth

My wife and I spend around 150 nights a year on the boat, so the vee berth matters. [www.irish-eyes-to-the-bahamas.blogspot.com]. When we bought Irish Eyes in 2004, the vee berth foam was shot, the...
Forum: Pacific Seacraft 04-17-2014
Replies: 9
Views: 756
Posted By wsmurdoch
Re: Rear oil seal

We have removed (and replaced) the transmission on our 3HM35F/KBW10.

(By my now 7 year old memory)

Break the prop shaft coupling and slide the shaft back a little
Disconnect the shift cable...
Forum: Pacific Seacraft 04-08-2014
Replies: 13
Views: 2,480
Posted By wsmurdoch
Re: PSC 34 compression post

At survey it would have been no trouble to remove the covering board over the wiring channel in the compression post. Ten screws held it in place. Had we removed it, the damage from the water...
Forum: Pacific Seacraft 04-07-2014
Replies: 13
Views: 2,480
Posted By wsmurdoch
Re: PSC 34 compression post

My original compression post had the appearance of white oak. The wiring groove in the port side was covered with a piece of perhaps 1/2" teak held in place with screws. Had I or the surveyor taken...
Forum: Pacific Seacraft 04-06-2014
Replies: 6
Views: 598
Posted By wsmurdoch
Re: Swivel or Not

Our staysail halyard is internal. It simply exits the mast over a sheave set into the slot in the mast below the staysail stay tang. There is no external block hung from the hole in the tang.
...
Forum: Pacific Seacraft 02-19-2014
Replies: 6
Views: 980
Posted By wsmurdoch
Re: Rudder Post Access Hatch

This is the access hole cover at the foot of the quarterberth. We use the space for storage, so there is blue carpet on the bottom. The HF antenna tuner is at the foot of the vee berth. The large...
Forum: Pacific Seacraft 02-10-2014
Replies: 9
Views: 608
Posted By wsmurdoch
Re: Microwaves vs. Crealocks'...

Something like this:

http://i602.photobucket.com/albums/tt107/wsmurdoch/Nav%20Station%20Microwave/StandUnNavDesk1.jpg
...
Forum: Pacific Seacraft 01-29-2014
Replies: 3
Views: 326
Posted By wsmurdoch
Re: Bottom Paint Coverage for PSC34

I buy 2 gallons of Interlux Micron Extra. That puts just over two coats on the bottom. I also use a little Interprotect to prime the bare spots on the keel and thru hulls.

Bill Murdoch
1988 PSC...
Showing results 1 to 25 of 166

 

All times are GMT -4. The time now is 05:16 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.