SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 56
Search took 0.03 seconds.
Search: Posts Made By: jb1528
Forum: Bristol 1 Week Ago
Replies: 6
Views: 252
Posted By jb1528
Re: Bristol 32 head floor

That does make some sense.

thanks

Jim
Forum: Bristol 1 Week Ago
Replies: 6
Views: 252
Posted By jb1528
Re: Bristol 32 head floor

My bilge stops just at or a bit forward of the galley. I have the standard keel. There is a platform in that area of the bilge for a shower pump which had been removed by the PO. I just don't know...
Forum: Bristol 1 Week Ago
Replies: 6
Views: 252
Posted By jb1528
Re: Bristol 32 head floor

Eric, the drain is no more than a hole in the floor about an inch in diameter with a molded tailpiece for the hose to go on to. it is a smaller version of the exhaust fitting in the stern. It sounds...
Forum: Bristol 1 Week Ago
Replies: 6
Views: 252
Posted By jb1528
Bristol 32 head floor

My 1975 B32 hull 165 has a drain in the floor of the head. Some day I shall need to replace the hose that runs to the pump for that grey water from the shower. Does anyone know if that floor can come...
Forum: General Discussion (sailing related) 1 Week Ago
Replies: 80
Views: 3,233
Posted By jb1528
Re: What did you learn to sail on?

My first sailboat was a Newport 16 fixed keel that I bought when I lived in Pullman Washington. I tried to sail it on the Snake River. I could do it now, but I couldn't then. After moving to western...
Forum: Introduce Yourself 4 Weeks Ago
Replies: 13
Views: 396
Posted By jb1528
Re: Another PNW sailor

Milkjug, welcome to the Sailnet forums. I sail out of Everett on my Bristol 32.I too sailed several small boats when I was younger and six or so years ago got back into it. I am also blessed with a...
Forum: Seamanship & Navigation 12-17-2013
Replies: 31
Views: 3,068
Posted By jb1528
Re: Why the Bristol 32 backs so poorly

MarkSF,

I guess we all have times when we control our boats without actually steering. The back and fill maneuver comes to mind. Some call that seamanship.

I have a Bristol 32 and can relate to...
Forum: Seamanship & Navigation 12-17-2013
Replies: 31
Views: 3,068
Posted By jb1528
Re: Why the Bristol 32 backs so poorly

I had a Catalina 27 before my Bristol32. The backing characteristics are very different. I have certainly learned with the Bristol that the bow will blow down very easily due to the underwater planes...
Forum: Bristol 06-26-2013
Replies: 6
Views: 675
Posted By jb1528
Re: Viewing a Bristol 32 tonight... Questions

This may be too little to late, but I purchases a 1975 32 recently. This is my third season. The fact that it is out of the water is good in my opinion as a surveyor would haul it anyway. You can do...
Forum: General Discussion (sailing related) 04-16-2013
Replies: 7
Views: 612
Posted By jb1528
Re: Bristol 30 up to 34

I bought a 1975 Bristol 32 two seasons ago. I thought I had a delamination in the vicinity of the through hulls in the head area. I didn't. The decks seem to be plywood cored. I don't have any delam...
Forum: Gear & Maintenance 03-09-2013
Replies: 47
Views: 2,669
Posted By jb1528
Re: Topsides going from 'White' to flag blue

I used tape with good results on my Catalina. By Bristol's cove is concave. I suppose masking is the answer.

it's academic at this point. Paint will come next year if at all.
Forum: Gear & Maintenance 03-09-2013
Replies: 47
Views: 2,669
Posted By jb1528
Re: Topsides going from 'White' to flag blue

After my first coat of Brightside doing roll and tip, the finish was not smooth. I called tech support and was given the brushing liquid advice. A sanding and second coat.....what a difference. That...
Forum: Gear & Maintenance 03-08-2013
Replies: 47
Views: 2,669
Posted By jb1528
Re: Topsides going from 'White' to flag blue

Barquito,

I did a black paint job with roll and tip using Brightside. USE THE BRUSHING LIQUID! I didn't on the first coat and it didn't flatten out. I hesitated to use it as the day was in the...
Forum: Gear & Maintenance 02-05-2013
Replies: 25
Views: 3,738
Posted By jb1528
Re: Shoot Thru Hull Transducer

I'm late to this discussion but wonder the best way to measure the deadrise angle given the boat rises perpendicular to the centerline and also fore and aft. At least that seams to be the case in my...
Forum: Bristol 10-01-2012
Replies: 7
Views: 847
Posted By jb1528
Re: Bristol 32 foward hatch support

Ok, the picture shows the hinge with the hatch open and on the middle notch of the arm. You will notice that the hinge halves are not parallel. When the hatch is closed, they are parallel.

I...
Forum: Bristol 09-28-2012
Replies: 7
Views: 847
Posted By jb1528
Re: Bristol 32 foward hatch support

Alan,
I went ahead and bought the perko windshield adjuster and installed it in August just before my cruise to the San Juans. The thing I learned is that when the hatch is closed, it aligns...
Forum: Gear & Maintenance 09-11-2012
Replies: 8
Views: 1,277
Posted By jb1528
Re: Bristol 32 rudder pivots

Well here is the deal with the lower rudder pivot on a Bristol 32.

At least on a 1975 vintage, hull 165, there is NO bronze shoe. There is a bushing set in the fiberglass that looks like it is a...
Forum: Gear & Maintenance 08-21-2012
Replies: 55
Views: 3,545
Posted By jb1528
Re: Waste Marine loses my business

I didn't read all the posts in this thread, but it is clear to me that what I learned over 25 years in retail is backed up by this discussion and that is that a satified customer will tell one friend...
Forum: Bristol 08-20-2012
Replies: 7
Views: 847
Posted By jb1528
Bristol 32 foward hatch support

Hey Bristol 32ers,

I couldn't find this in the forum so please excuse me if I missed it. I'd like to learn what the OEM forward hatch support was. I bought hull 165 last year and immediately broke...
Forum: Bristol 07-26-2012
Replies: 3
Views: 644
Posted By jb1528
Re: B32 rudder shaft repair

If it is common then perhaps someone knows the answer to one more part of the mystery for me. Why is the bottom end of the pin threaded? The yard that did the repair said it was 1/4 20 threads. Is it...
Forum: Bristol 06-27-2012
Replies: 3
Views: 644
Posted By jb1528
Re: B32 rudder shaft repair

I want to add one thing that I wasn't clear on until last night. The bolt that is oriented athwart ship goes through the rudder pin. I though it was under the pin and the pin simply rested on it. As...
Forum: Bristol 06-26-2012
Replies: 4
Views: 1,770
Posted By jb1528
Re: Bristol 32- Deck Stepped Mast - Lighting Protection

I just finished a repair that involved removing two 1 1/2 sea cocks in the head on my Bristol 32 with a deck stepped mast. The valves appeared to be bonded with wire but I noticed that not all the...
Forum: Bristol 06-25-2012
Replies: 3
Views: 644
Posted By jb1528
B32 rudder shaft repair

When I bought my B32 last year the survey showed a loose lower rudder shaft. I assumed it was the bushing in a cast bronze shoe. Nope. Turns out that this particular vessel doesn't have a bronze...
Forum: Bristol 06-25-2012
Replies: 6
Views: 1,009
Posted By jb1528
Re: Moisture delam at through hulls

Well in the event anyone cares to know, what I thought was delamination, was a change in accoustic properties brought on by a wooden backing plate to a seacock. No delamination. I did have the two...
Forum: Boat Review and Purchase Forum 04-20-2012
Replies: 38
Views: 2,966
Posted By jb1528
Re: Help us choose a boat, please

I just don't fill that tank. 70 in the keel tank is plenty. If I do need to cruise with that 30 gallons in the bow, I'll split the chain and put 50ft of it in the stern for the 2nd anchor, but I...
Showing results 1 to 25 of 56

 

All times are GMT -4. The time now is 01:07 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012