SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 13 of 13
Search took 0.01 seconds.
Search: Posts Made By: KVK
Forum: Gear & Maintenance 09-16-2010
Replies: 6
Views: 777
Posted By KVK
No worries... Check the outside cable cover for...

No worries...
Check the outside cable cover for type/manufacturer and go from there.
Kevin
Forum: Gear & Maintenance 09-16-2010
Replies: 6
Views: 777
Posted By KVK
Nice boat Jim...i just checked out your site. ...

Nice boat Jim...i just checked out your site.

Knowing your control cable type is important and then go from there.
Replacing cable controls is expensive!

You are two day UPS ground.
Forum: Gear & Maintenance 09-16-2010
Replies: 6
Views: 777
Posted By KVK
jarcher - If you can use Morse 33c cable, i...

jarcher -
If you can use Morse 33c cable, i have this posted on ebay....
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices...
Forum: Diesel 06-27-2010
Replies: 11
Views: 5,692
Posted By KVK
Tytower - the blue thinggy was the prop...

Tytower - the blue thinggy was the prop connector, connecting the prop shaft to the transmission end. The barrel bolt is found inside the Martec folding prop hub and is threaded unto the end of the...
Forum: Diesel 06-27-2010
Replies: 8
Views: 1,065
Posted By KVK
I recently had the challenge of changing filters...

I recently had the challenge of changing filters on a 5411, and then try to crank the diesel engine to bleed the air out. I opted to install a fuel bulb between the tank and first fuel filter. A...
Forum: Diesel 06-18-2010
Replies: 11
Views: 5,692
Posted By KVK
Compassrose - my first thought regarding your...

Compassrose - my first thought regarding your transmission challenges is the lack of oil wasn't good for tranny. The wear on the clutch pack would increase without lubrication oil. There is a guy...
Forum: Diesel 05-30-2010
Replies: 11
Views: 5,692
Posted By KVK
The HBW-5 needed forward and reverse clutch...

The HBW-5 needed forward and reverse clutch packs, one thrust washer and a new damper plate...i retrieved the tranny on Friday and everything is back together, except for the LH prop. I repositioned...
Forum: Diesel 05-22-2010
Replies: 11
Views: 5,692
Posted By KVK
The damper plate is the center of the flywheel...

The damper plate is the center of the flywheel assembly and is removed with the eight allen set screws. I removed it and delivered the trans to American Transmissions in Edgewater, MD yesterday for...
Forum: Diesel 05-21-2010
Replies: 11
Views: 5,692
Posted By KVK
I appreciate the replies and words of...

I appreciate the replies and words of wisdom/experience. I got into yesterday after she was pulled from the bay the day before. My thinking was options available, and there was only one way to get...
Forum: Diesel 05-16-2010
Replies: 11
Views: 5,692
Posted By KVK
Hurth HBW-5 Transmission

I am "sailing" new waters with our Santana 30, and am asking for help/advice. The slipping tranny has passed from a semi-functional state to reverse only! Now begs the question of what to do...I've...
Forum: Gear & Maintenance 12-30-2008
Replies: 7
Views: 1,577
Posted By KVK
I am asking for some help and have questions as...

I am asking for some help and have questions as to how do “timbers” along with keel bolts secure a keel to the hull? Are the timbers shaped and then glassed in the hull layups? I have two timbers,...
Forum: Gear & Maintenance 12-27-2008
Replies: 7
Views: 1,577
Posted By KVK
thanks for the feedback...and the boat in...

thanks for the feedback...and the boat in question is a modified Santana 30. Schock made 118 of these and ended the run in 1980. It is frustrating not being able to pinpoint where the water is...
Forum: Gear & Maintenance 12-22-2008
Replies: 7
Views: 1,577
Posted By KVK
Seepage around keel bolts

i am looking for some ideas regarding our newly aquired sailboat. I have noticed water seepage near the aft pair of keel bolts. When the boat was purchased, she was on the hard and the bilge was...
Showing results 1 to 13 of 13

 

All times are GMT -4. The time now is 03:22 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.