SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 20 of 20
Search took 0.01 seconds.
Search: Posts Made By: Summercamp
Forum: Gear & Maintenance 10-18-2012
Replies: 15
Views: 667
Posted By Summercamp
Please recommend custom tank makers

I need a new water tank and and a new holding tank. Both will require a custom made tank as I can't find one of the correct size or shape that are rotomolded and readily available (Ronco, Raritan,...
Forum: General Discussion (sailing related) 01-21-2012
Replies: 5
Views: 1,500
Posted By Summercamp
Diesel soaked plywood - can I scrub and paint

I have marine plywood knees that support my cabin sole. Two of them also extend down to the bottom of the keel. At some point they have been soaked with diesel due to a leaky diesel tank. I can...
Forum: Gear & Maintenance 09-02-2011
Replies: 1
Views: 501
Posted By Summercamp
adding cabinets in a v-berth

I am looking at my v-berth and have considered adding a sail locker to one half of the forward area. I have also considered adding a cabinet that would be mounted above the berth and attached to the...
Forum: Gear & Maintenance 09-02-2011
Replies: 2
Views: 621
Posted By Summercamp
Repairing a hole in deck - use core material of laminate

The previous owner of my Pacific Seacraft 25 installed a windlass just aft of the bow sprit. I have removed the windlass and would like to eliminate the hawsehole which, given the small size of the...
Forum: Gear & Maintenance 10-28-2010
Replies: 9
Views: 1,243
Posted By Summercamp
There are no small wet spots in plywood you may...

There are no small wet spots in plywood you may be able to live with wet in some areas BUT what boat you are repairing is a factor as someone who has owned a J24 were the inner and out skins merge...
Forum: Gear & Maintenance 10-28-2010
Replies: 9
Views: 1,243
Posted By Summercamp
It is 3/8 plywood. The entire deck is 3/8...

It is 3/8 plywood.

The entire deck is 3/8 plywood and with the exception of the stanchion the soft area is not under a high stress area such as a windless. My plan is to use fiberglass where...
Forum: Gear & Maintenance 10-28-2010
Replies: 9
Views: 1,243
Posted By Summercamp
recoring help needed

I am preparing to fix some soft spots on some decking which currently has 3/ inch plywood for the core. For my core replacement material I am questioning whether to replace the rotten core with...
Forum: Gear & Maintenance 09-23-2010
Replies: 6
Views: 637
Posted By Summercamp
You are right....maybe I am bit too optimistic...

You are right....maybe I am bit too optimistic about the 6" x 6" area ;)
It would appear that water intrusion occured due to impact damage when someone dropped an anchor or case of cold beer on the...
Forum: Gear & Maintenance 09-23-2010
Replies: 6
Views: 637
Posted By Summercamp
You are right....maybe I am bit too optimistic...

You are right....maybe I am bit too optimistic about the 6" x 6" area ;)
It would appear that water intrusion occured due to impact damage when someone dropped an anchor or case of cold beer on the...
Forum: Gear & Maintenance 09-22-2010
Replies: 6
Views: 637
Posted By Summercamp
Hiding core damage repairs in non-skid areas

Hello,

I am new to repairing decks. I have read and understand the process of cutting the skin and replacing the core (if needed) from the outside. Also aware of the process of drilling holes and...
Forum: Diesel 03-17-2010
Replies: 6
Views: 2,215
Posted By Summercamp
Best book on repairing marine diesel

I am getting ready to work on a Yanmar YSM8 which ran (with some troubles)for the last owner and has sat for some time. I would like to purchase a good book for working on marine diesel engines. I...
Forum: General Discussion (sailing related) 12-12-2009
Replies: 10
Views: 2,512
Posted By Summercamp
Looking in VA or MD for Teak board & plywood distr.

I am looking for a supplier for some teak boards and plywood in VA or MD. I would like to find some with a good selection and good prices.

Any recommendations?

Thanks
Forum: General Discussion (sailing related) 12-12-2009
Replies: 10
Views: 2,512
Posted By Summercamp
Looking in VA or MD for Teak board & plywood distr.

I am looking for a place that handles quality teak boards and marine grade teak veneer plywood. I would like to find a place with a nice selection and good prices.

Thanks
Forum: Pacific Seacraft 09-29-2009
Replies: 45
Views: 6,663
Posted By Summercamp
gasket size to match PS25 oval portlights

Would this same size work for oval bronze portlights in a 78 PSC25? Just took them apart last night.
Forum: Gear & Maintenance 09-22-2009
Replies: 12
Views: 2,912
Posted By Summercamp
restoring gelcoat - Need Help

I have a 1978 PSC25. The previous owner has taken all of the hardware off the boat in preparation to paint the entire boat. I am debating the merits of this plan and looking at the the pros and...
Forum: Gear & Maintenance 09-22-2009
Replies: 5
Views: 1,605
Posted By Summercamp
Rebuilding bronze portlights

I need to rebuild all six of my bronze portlights on a 1978 PSC25. Three have broken glass, all need new gaskets. I am weighing the idea of doing it myself versus sending them off to be re-built. I'm...
Forum: General Discussion (sailing related) 08-28-2009
Replies: 11
Views: 4,481
Posted By Summercamp
I have a PSC 25 and a little Flying Scot. I am...

I have a PSC 25 and a little Flying Scot. I am wanting to spend more time on the Pacific Seacraft. Public or Charter school would be best on the budget. We will be relocating from WV and will...
Forum: General Discussion (sailing related) 08-28-2009
Replies: 11
Views: 4,481
Posted By Summercamp
We are trying to stay close to D.C. where I...

We are trying to stay close to D.C. where I travel for work most weekends during Jan to mid-March. I would like to avoid a location where I would have to fly to DC. Another factor (almost bigger...
Forum: General Discussion (sailing related) 08-28-2009
Replies: 11
Views: 4,481
Posted By Summercamp
North Carolina - best place for sailing???

My wife and I are looking at relocating for a few years to N. Carolina. I am an intermediate skilled sailor and wanting to spend a more time on the water to advance my skills. We also need a small...
Forum: Bristol 03-25-2009
Replies: 20
Views: 20,286
Posted By Summercamp
Bardo's Bristol 29 for sale?

Does anyone know if Bardo still has his Bristol for sale? I tried sending him a personal message but as a new member to this group I need to have five postings.
Showing results 1 to 20 of 20

 

All times are GMT -4. The time now is 11:05 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.