SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 18 of 18
Search took 0.03 seconds.
Search: Posts Made By: Fstbttms
Forum: General Discussion (sailing related) 3 Days Ago
Replies: 15
Views: 592
Posted By Fstbttms
Re: Best place in California to sail and live on your boat?

Both bases have been converted to civilian use. Treasure Island still has it's marina and is a small boat sailing center. NAS Alameda is now home to tech companies, distilleries, craft breweries and...
Forum: Gear & Maintenance 05-06-2014
Replies: 42
Views: 1,656
Posted By Fstbttms
Re: Ablative vs. Hard Paints....

The way I see it, you have a couple of options:

Determine what kind of paint you have. If it's ablative, pressure wash the dried slime off and launch (assuming you haven't blasted all the paint...
Forum: Electrical Systems 05-05-2014
Replies: 2
Views: 316
Posted By Fstbttms
Re: Electrolysis When on a Mooring

This occurred within a few week span. Cause was a bare bilge pump wire in a damp bilge.

http://www.fotolode.com/images/fstbttms/Hull-cleaning/nassoiy004.jpg
Forum: Gear & Maintenance 04-05-2014
Replies: 105
Views: 3,953
Posted By Fstbttms
Re: Copper sheeting & CopperCoat anti-fouling

It is a common misconception that since the Navy is exempt from U.S. environmental regulations concerning anti fouling paint, that they use special paints that the rest of us cannot. The reality is...
Forum: Gear & Maintenance 03-29-2014
Replies: 33
Views: 1,162
Posted By Fstbttms
Re: Bottom slime

Again, you seem to be missing the very point you went to such great lengths to make (albeit perhaps not intentionally)- the slime that fouls boat hulls is not the same as the slime that fish create...
Forum: Gear & Maintenance 03-29-2014
Replies: 33
Views: 1,162
Posted By Fstbttms
Re: Bottom slime

Fish are not sailboats and the slime they produce is not marine fouling. Apples and oranges.



I'd venture to say that nobody reading this (certainly not the OP) is using foul release coatings,...
Forum: Gear & Maintenance 03-29-2014
Replies: 33
Views: 1,162
Posted By Fstbttms
Re: Bottom slime

Almost, but not quite. The biocide leach rate is not reduced, it continues unabated as long as the hull is in the water until the biocide is depleted, regardless of how much growth is on the hull....
Forum: Gear & Maintenance 03-28-2014
Replies: 33
Views: 1,162
Posted By Fstbttms
Re: Bottom slime

If you think sailing with a dirty bottom is somehow faster than sailing with a clean one, I've got a bridge in Brooklyn to sell you. :rolleyes:

As far as regular cleaning goes, doing it relatively...
Forum: Gear & Maintenance 03-28-2014
Replies: 83
Views: 4,465
Posted By Fstbttms
Re: Any ideas on this Hooka type dive compressor system?

It can be an issue, I suppose. I don't actually install a lot of the single-piece ring anodes on sail drives, because they tend to last a long time but also because it requires pulling the prop and...
Forum: Gear & Maintenance 02-27-2014
Replies: 38
Views: 1,292
Posted By Fstbttms
Re: new bottom cleaning kit

When you can take the pebble from my hand, it will be time for you to leave, Grasshopper. :D
Forum: Gear & Maintenance 02-17-2014
Replies: 38
Views: 1,292
Posted By Fstbttms
Re: new bottom cleaning kit

I've been cleaning boat bottoms for almost twenty years. Here's a basic tool kit:

3M Doodlebug pads and holders
Suction cup
3M wire brush w/scraper
6" scraper
5-in-1 tool
Flathead screwdriver...
Forum: Cal 01-04-2014
Replies: 5
Views: 812
Posted By Fstbttms
Re: Cal 31 Prop Shaft Diameter?

It's gotta be 1". Cant imagine it being anything else.
Forum: Gear & Maintenance 09-20-2013
Replies: 8
Views: 412
Posted By Fstbttms
Re: Shaft bearing changout - waterborne?

Jeezus. Just haul the boat for God's sake. http://www.fotolode.com/images/fstbttms/Emoticons/rolleyes.gif
Forum: Introduce Yourself 08-31-2013
Replies: 16
Views: 1,134
Posted By Fstbttms
Re: My First Cruiser: Pearson Triton

The Triton does not have a tabernacled mast. The spar simply sits in the step and is held there by rigging tension.

Buying a boat like this, sight unseen, is a big gamble, IMHO. Good luck. Hope it...
Forum: Gear & Maintenance 08-15-2013
Replies: 2
Views: 349
Posted By Fstbttms
Re: Flexifold and strut

1.- Remove the zinc.
2.- Remove the cover plate.
3.- Remove the set-screws that secure each blade pivot pin.
4.- Drive out the pivot pins.
5.- Remove the blades.
6.- Remove prop nut set screw...
Forum: Chesapeake / Central US east coast 08-05-2013
Replies: 25
Views: 1,380
Posted By Fstbttms
Re: Diver needed - Edgewater Maryland

Don't know any of these outfits so can't comment on reliability:

Commander Dive Service (http://www.commanderdive.com)

DMH Dive Services - Search and Retrieve, overboard lost items, hull...
Forum: General Discussion (sailing related) 07-08-2013
Replies: 30
Views: 847
Posted By Fstbttms
Re: Replacing propellor in the water?

I can't tell you what paying a diver would cost you in your neck of the woods, but here in the Bay Area, prop R&R is $10/inch diameter. You'd probably be looking at $150-$170 or so.
Forum: Gear & Maintenance 06-22-2013
Replies: 16
Views: 1,234
Posted By Fstbttms
Re: Pigtail Adapter: 30A to household 15a plug

I go the other way 'round. Every day I plug my 110-volt, 10.5 amp, 1.25 hp air compressor into 30 amp shorepower using a 16-gauge extension cord. Have done for almost 19 years. Never a problem.
Showing results 1 to 18 of 18

 

All times are GMT -4. The time now is 12:05 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012