SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: SteveInMD
Forum: General Discussion (sailing related) 06-21-2014
Replies: 164
Views: 7,612
Posted By SteveInMD
Re: Help me plan my cruise North!

I should also add, a few hours before leaving Cape May give everyone a dose of Bonine. It's does not tend to knock you out like Dramamine can. It lasts 24 hours. You can reduce the dose if all is...
Forum: General Discussion (sailing related) 06-20-2014
Replies: 164
Views: 7,612
Posted By SteveInMD
Re: Help me plan my cruise North!

I'm doing a similar trip now. As for gear...
I wanted a no stress coastal trip with the family and went with a chart plotter, AIS, radar, and laptop with nav software at the navigation station. I...
Forum: Electronics 06-15-2014
Replies: 1
Views: 294
Posted By SteveInMD
Re: Raymarine AIS 650

I've had mine for a few months and have had no issues. I use it with my e95 plotter at the helm and also have a USB cable connected from it to my laptop at the navigation station. I'm running...
Forum: Diesel 06-03-2014
Replies: 2
Views: 271
Posted By SteveInMD
Re: Siphon between heat exchanger and mixing elbow?

The previous owner of my boat created a siphon break from household pvc fittings and threaded the anti siphon valve to the top of it. While this setup worked fine for many years, I just replaced it...
Forum: Gear & Maintenance 06-02-2014
Replies: 48
Views: 2,315
Posted By SteveInMD
Re: Starting engine with charger on

I have seen one situation related to this that left me scratching my head a bit. It was slow crank / high current draw situation from bad wiring in the key switch side. The key switch starting...
Forum: Gear & Maintenance 05-29-2014
Replies: 25
Views: 1,129
Posted By SteveInMD
Re: Bird nests in the boom

A drink coozie fits perfectly for me. Plus it's in easy reach when sailing.
Forum: Gear & Maintenance 05-18-2014
Replies: 32
Views: 1,664
Posted By SteveInMD
Re: Fuel tank sending units / gauges

I replaced my sender with a mechanical unit. The guage sits on top of the tank. It's totally reliable. Depending on where your tank is this may be an alternative for you.
Forum: Gear & Maintenance 05-18-2014
Replies: 48
Views: 2,315
Posted By SteveInMD
Re: Starting engine with charger on

It sounds to me like you should do a load test on your batteries.

Do you know how your high output alternator is wired? One thing that can make cranking easier is to connect the excite wire for...
Forum: Gear & Maintenance 05-14-2014
Replies: 25
Views: 1,672
Posted By SteveInMD
Re: Diesel bleeding.. havei damaged severly

It's very hard to describe the bleeding process in a meaningful way unless you understand there are two sections of the fuel system - the low pressure feed side and the high pressure (injector) side....
Forum: Electronics 05-11-2014
Replies: 16
Views: 877
Posted By SteveInMD
Re: AIS / Marine Traffic

Thank you. I may take you up on that at some point.

FWIW...

I was being picked up sporadically on MarineTraffic and aprs.fi this weekend. Both sites listed K3ARS as the source. K3ARS is in...
Forum: Diesel 05-09-2014
Replies: 24
Views: 1,262
Posted By SteveInMD
Re: How often to change impeller?

I think it has been six years since I've changed mine. If I remember correctly I have to jack up the motor and remove a motor mount to get to it. Brilliant design.
Forum: Electronics 05-09-2014
Replies: 16
Views: 877
Posted By SteveInMD
Re: AIS / Marine Traffic

Well everything else is working and their wiring is neat and orderly. Prettier than I could / would have done. Hopefully the quality is there too.



Agreed. That's why I'm surprised I'm not...
Forum: Diesel 05-09-2014
Replies: 24
Views: 1,262
Posted By SteveInMD
How often to change impeller?

I have a Yanmar 4JH2E. I had been under the impression that changing the raw pump impeller was just part of normal annual maintenance. I was told by a mechanic that the impeller is rated for 1,500...
Forum: Electronics 05-08-2014
Replies: 16
Views: 877
Posted By SteveInMD
Re: AIS / Marine Traffic

Thanks. My system was professionally installed; I hope it's not an installation problem. There is a boat called Bernadette that has her AIS on 24/7 in Chesapeake Harbour. I don't see her on either...
Forum: Electronics 05-08-2014
Replies: 16
Views: 877
Posted By SteveInMD
Re: AIS / Marine Traffic

Marine Traffic did pick me up once while going under the Chesapeake Bay Bridge, so I think I'm transmitting. My slip is in Chesapeake Harbour near Annapolis. Perhaps the base station listed on the...
Forum: Electronics 05-08-2014
Replies: 16
Views: 877
Posted By SteveInMD
AIS / Marine Traffic

Now that I have an AIS system (Raymarine AIS650) why don't a show up on Marine Traffic? When I look at the target data using proAIS2 it shows a base station about 1 mile from me. Can someone...
Forum: Gear & Maintenance 04-30-2014
Replies: 20
Views: 1,297
Posted By SteveInMD
Re: Exterior Night Lighting Ideas

Amazon.com: LEDJump Waterproof 16.4Ft RGB SMD5050 Color Changing LED Taped Flexible Strip 44 Button remote Controller with 5A Power Supply Complete Set (cuttable and Linkable): Home...
Forum: Gear & Maintenance 04-28-2014
Replies: 4
Views: 339
Posted By SteveInMD
Re: Aluminum fuel tank fittings

Thanks. When I called I was told me it would be a special order part and would only do that for a business.
Forum: Gear & Maintenance 04-28-2014
Replies: 4
Views: 339
Posted By SteveInMD
Aluminum fuel tank fittings

Does anyone know a supplier of aluminum fuel tank fittings?

I need two elbows - 1/2" male NPT x 1/2" barb, and a 1/2" male NPT x 5/16" barb
Forum: Gear & Maintenance 04-25-2014
Replies: 7
Views: 401
Posted By SteveInMD
Re: Battery charger install clearance?

I believe the goal is to keep the hydrogen gas that the batteries can produce away for the an ignition source. I would build or buy a battery box and vent it to the exterior. I don't think you need...
Forum: Electronics 04-25-2014
Replies: 5
Views: 378
Posted By SteveInMD
Re: new Instrument install

I had the Raymarine dealer install my new transducers. The new thru-hull fittings were larger than the olds ones, so they drilled them out. Then they used an adhesive for the installation, not...
Forum: Electronics 04-23-2014
Replies: 0
Views: 195
Posted By SteveInMD
Nobeltec TimeZero Odyssey

Has anyone tried Nobeltec TimeZero Odyssey nav software? If so did you have it connected to a Raymarine system? I was told this is a good combination. Does it do more than Open CPN can do?
Forum: Gear & Maintenance 04-22-2014
Replies: 12
Views: 949
Posted By SteveInMD
Re: Engine room cleanup - better way?

+1 for citrus oil based cleaner and hot water
Forum: Electronics 04-20-2014
Replies: 6
Views: 503
Posted By SteveInMD
Re: CB radio with SSB

The way I understand it is...using SSB mode is an attempt to get more range from the radio. If you and another CB station agreed to communicate using a single sideband (SSB) mode and which side,...
Forum: Electronics 04-19-2014
Replies: 25
Views: 1,135
Posted By SteveInMD
Re: Chartplotter at the nav station

I've been using GPS (in place of Loran) with paper charts from the early days of GPS, then GPS with a laptop chart plotting software, then chartplotters. I've found them to be totally reliable -...
Showing results 1 to 25 of 500

 

All times are GMT -4. The time now is 06:28 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.