SailNet Community - Search Results

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > Search Forums
 Not a Member? 


Showing results 1 to 25 of 131
Search took 0.02 seconds.
Search: Posts Made By: jones2r
Forum: Gear & Maintenance 11-03-2007
Replies: 10
Views: 2,528
Posted By jones2r
Permatex/LocTite makes an Ultra Blue RTV sealant...

Permatex/LocTite makes an Ultra Blue RTV sealant that stands up to about anything (fuel,heat,etc.). Should be available at any of the chain auto stores. Follow the instructions for permanence.
Forum: Gear & Maintenance 10-29-2007
Replies: 6
Views: 4,961
Posted By jones2r
I've used a Veederoot handheld counter in...

I've used a Veederoot handheld counter in conjunction with the sweep hand on my wristwatch; very accurate. It would probably be held against the harmonic balancer retaining bolt (inside of the...
Forum: Gear & Maintenance 10-29-2007
Replies: 29
Views: 8,236
Posted By jones2r
The following SailNet article addresses this...

The following SailNet article addresses this problem with autopilots in general:

http://www.sailnet.com/forums/showthread.php?t=20065&highlight=autopilot
Forum: Boat Review and Purchase Forum 10-27-2007
Replies: 9
Views: 1,251
Posted By jones2r
Here's a good place to start: ...

Here's a good place to start:

www.yachtworld.com/index.html.en

You will need to provide more specifics, like size of budget and size of boat, for anyone to make meaningful recommendations.
...
Forum: Gear & Maintenance 10-24-2007
Replies: 7
Views: 4,320
Posted By jones2r
If the epoxy repair sounds attractive to you,...

If the epoxy repair sounds attractive to you, Loctite makes a two-part, clear product that, while not flexible, is not totally rigid (if that makes any sense). It should make a minimally obtrusive...
Forum: Gear & Maintenance 10-24-2007
Replies: 38
Views: 2,122
Posted By jones2r
PB Blaster, or a similar penetrating oil (Knock R...

PB Blaster, or a similar penetrating oil (Knock R Loose, Liquid Wrench) followed by lightly tapping with a hammer for a protracted period of time will break the corrosive bond. Might give it a try...
Forum: Gear & Maintenance 10-24-2007
Replies: 7
Views: 1,730
Posted By jones2r
Westerbeke is the supplier for Universal engines....

Westerbeke is the supplier for Universal engines. Their website is:

www.westerbeke.com

I have had positive experience with their technical support in the past when e-mailed.
Forum: Gear & Maintenance 10-23-2007
Replies: 17
Views: 7,173
Posted By jones2r
If you look at the bottom of this page, you will...

If you look at the bottom of this page, you will see a reference to an article by Tom Wood on winch maintenance. It's worthwhile reading. For those averse to the expense of proprietary grease, he...
Forum: Gear & Maintenance 10-22-2007
Replies: 19
Views: 1,806
Posted By jones2r
Any chance that a throttle calibration was...

Any chance that a throttle calibration was disturbed when the "solenoid" was actuated manually?
Forum: General Discussion (sailing related) 10-17-2007
Replies: 22
Views: 1,684
Posted By jones2r
Thanks for the warning. Lord knows what would...

Thanks for the warning. Lord knows what would happen to the guy who brought wine.
Forum: Gear & Maintenance 08-06-2007
Replies: 76
Views: 4,103
Posted By jones2r
Velcro. Put it in any of a number of places.

Velcro. Put it in any of a number of places.
Forum: Gear & Maintenance 07-01-2007
Replies: 25
Views: 2,962
Posted By jones2r
Does MapTech have a setup routine? If the...

Does MapTech have a setup routine? If the numbers you have given correlate accurately, the readout may be in kilometers per hour rather than knots.
Forum: Gear & Maintenance 04-24-2007
Replies: 3
Views: 1,543
Posted By jones2r
Diesels will run on all kinds of gunk, except...

Diesels will run on all kinds of gunk, except water. Since it eventually starts and runs, it may not be a fuel issue. The symptoms suggest a sticking intake valve, which will compromise...
Forum: Gear & Maintenance 04-23-2007
Replies: 27
Views: 8,972
Posted By jones2r
Are You Sure?

How was it determined that the block is cracked? The climate in your area isn't typically severe enough to cause this kind of damage. While I'm not experienced with fresh water systems, I would...
Forum: Gear & Maintenance 01-24-2007
Replies: 9
Views: 949
Posted By jones2r
Be sure the welder knows that he is working with...

Be sure the welder knows that he is working with stainless. In a boat yard it should be a given, but .... Also, he should be using a TIG machine.
Forum: Gear & Maintenance 01-24-2007
Replies: 4
Views: 3,711
Posted By jones2r
You need to look at what will have to be...

You need to look at what will have to be reconfigured in the boat to accept the different power plant. How will the existing transmission adapt? Will the shaft length be the same? Will a different...
Forum: Gear & Maintenance 01-24-2007
Replies: 14
Views: 4,372
Posted By jones2r
A compression test in addition to the recommended...

A compression test in addition to the recommended engine oil analysis will tell a lot about wear. Check the hot oil pressure at both idle and operating speed. If you keep what you have, it might be...
Forum: Boat Review and Purchase Forum 01-22-2007
Replies: 31
Views: 25,406
Posted By jones2r
SD -- I hate to be the one to bring this up, but...

SD -- I hate to be the one to bring this up, but how did you manage to dig up a 5 year old thread?
Forum: General Discussion (sailing related) 01-20-2007
Replies: 51
Views: 2,664
Posted By jones2r
IIRC, the Panama Canal is 105ft. wide, and the...

IIRC, the Panama Canal is 105ft. wide, and the Missouri is 103ft. wide. So, if you scale your boat's length to the Missouri's length (don't know that number OTTOMH) and then calculate the...
Forum: Boat Review and Purchase Forum 01-20-2007
Replies: 245
Views: 14,638
Posted By jones2r
"...besides If I go I might get accused of...

"...besides If I go I might get accused of something"

I find that hard to believe.
Forum: Cruising & Liveaboard Forum 01-20-2007
Replies: 36
Views: 4,014
Posted By jones2r
HS, "...don't you know, the next week the...

HS,
"...don't you know, the next week the columnist apologized for the error in the problem..."
I wonder if the staffer who set the columnist up had a job afterward?

I'm hardly a source for...
Forum: Boat Review and Purchase Forum 01-20-2007
Replies: 29
Views: 1,931
Posted By jones2r
Otaga, Thank you for posting. These...

Otaga,

Thank you for posting. These contributions will benefit many of us.
Forum: Boat Review and Purchase Forum 01-20-2007
Replies: 245
Views: 14,638
Posted By jones2r
"You're more of a domestic Stupid.....kind'a like...

"You're more of a domestic Stupid.....kind'a like home made stuff...."
Careful. You're vulnerable.

BTW, did you see where you've been invited to have lunch with Kermie? You get to bring the...
Forum: Gear & Maintenance 01-20-2007
Replies: 53
Views: 4,256
Posted By jones2r
Sounds like a Portagee with Italian ancestry.

Sounds like a Portagee with Italian ancestry.
Forum: Boat Review and Purchase Forum 01-20-2007
Replies: 245
Views: 14,638
Posted By jones2r
Damned Europeans are all alike. French,...

Damned Europeans are all alike. French, Italians, Portuguese ...

stupid foreigners
Showing results 1 to 25 of 131

 

All times are GMT -4. The time now is 07:10 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012