Join Date: Sep 2009
Location: Eugene, Oregon
Thanked 2 Times in 2 Posts
Rep Power: 0
I tried to post some pictures yesterday but I was not able to upload the pictures. Kept getting an error.
I did some research on my mast and boom today. Turns out I have a mast and boom manufactured by "Isomat". Did a search and found a web site that has parts for the goose neck assembly. "rigrite.com" .The site says they specialize in hard to find parts. I'm going to check if they have the torque bearings for the furler.
Next project is to find some tubing for the table. The brackets have a 1" diameter ID holes for the post. I'm thinking of using 304 stainless steel tubing for the post. Only problem is I'll need to bend it. I'm thinking of using a electrical conduit bender to bend the tube. Do you think it will work?
Did you have a good day sailing?