SailNet Community banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Galley, Heads, Plumbing, Propane, Water etc
    As I look towards spring and start to get the new to me boat ready I noticed that my airmar thru hull transducer has a flapper on the thru hull when I pull it so an extra plug can be quickly swapped into it so the knotmeter paddle wheels can be cleaned. Great, seems like a great idea. However...
  2. Electronics
    Greetings, I purchased an Airmar DST800v direct from Airmar because I wanted the bronze through hull and not the plastic one that comes with the Garmin version of the device. However, instead of a connector, the end of the very long wire harness has a bunch of wires and no connector. This may...
  3. Electronics
    The triducer works fine for depth and speed, but the water temp in the Chesapeake is NOT 112! It is an NMEA 2000 model connected to a Ray E7. Where do I start?
  4. Electronics
    I am looking to add a fast heading sensor to a Raymarine e127 for MARPA and Radar overlay. The Airmar H2183 comes in two flavors NMEA2000 or NMEA183. Has anyone installed this unit with the new e127 MFD? It looks simple enough. George
  5. Electronics
    Hi everyone, In the past couple of days I have been trying to install a simple NMEA 2K network consisting of a Garmin GMI 10 MFD, an Airmar 800DST Triducer, a Garmin GWS 10 Wind sensor and a Garmin GPS 19X HVS (NMEA0183 version). So far I have only dealt with the triducer, gps and the display...
1-5 of 5 Results