SailNet Community banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Galley, Heads, Plumbing, Propane, Water etc
    After months of forced isolation very far away from our boat, we came back and found a poor looking through hull for our sink/freezer drain. The boat is an Oceanis 41, 7 years old, and sat at the dock, with a galvanic isolator. Anodes have been changed regularly and bottom cleaned by a diver...
  2. Gear & Maintenance
    Hi, I have a 7/8" OD seacock. The head intake has a 3/4" ID sanitation hose forced onto this 7/8" seacock. I would like to replace the hose to a more suitable inlet water & heater hose. I can't find any reducer of 7/8" to 3/4". Should I buy a 3/4" ID hose and force it onto the 7/8" seacock...
  3. Gear & Maintenance
    This seacock has a manifold for multiple hoses and a plunger type handle. I can only get one photo to upload. Photo of handle and plunger to follow.
  4. Gear & Maintenance
    So I have gotten most of my seacocks apart to lap and grease but can't get the last two. They are spartan cone plugs. I've tried: Heat gun Pb blaster Hitting with dead blow hammer PVC for increased leverage ( I started to bend the handle so that's not the ticket) I'm out of ideas. Is the...
  5. Gear & Maintenance
    I'm looking for the size of the cockpit drain seacock and thru hull for a 1973 Irwin 28.5
1-5 of 5 Results