SailNet Community banner
Cancel
  • SailNet is a forum community dedicated to Sailing enthusiasts. Come join the discussion about sailing, modifications, classifieds, troubleshooting, repairs, reviews, maintenance, and more!

adhering plywood to fiberglass

17416 Views 6 Replies 6 Participants Last post by  mitiempo, 
tfenker
I have a '75 Islander 28. The ply has delamenated due to leakage @ the ports. We have removed all the ply from inside & have cut new ply to replace with. I can't seem to get an answer on what type of adhesive to use. The ply is teak veneer & will be applied to fiberglass. Any answers?
Reply
Save
Like
1 - 2 of 7 Posts
tfenker
The existing 1/4" ply appeared to have been oil stained on the interior face.The ports are being replaced,thats the rub.The interior trim rings will be cut to match the hull thickness,including said ply. Would a one part urathene glue (i.e. Gorilla) be a feasible?
Reply
Save
Like
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
SailNet Community
A forum community dedicated to Sailing enthusiasts. Come join the discussion about sailing, modifications, classifieds, troubleshooting, repairs, reviews, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussion - Sailing Related Gear & Maintenance Boat Review Forum Cruising & Liveaboard Forum Seamanship & Navigation
Top