SailNet Community banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Reaction score
0
howto: applying furring strips to fiberglass hull ....BUMP!

Saw the post from 2001 but did not see any resolution.

It is now my turn to figure out this issue. The idea of what type of wood to use as a furring strip, how to fasten them to the hull and what type of fastener to use. I have a bare hull essentially. I was thinking about using 1x2 pine. Cheap and easy to bend. Screwing them into the hull. I am lucky as the hull is insulated with another layer of glass over it. However in some parts, mainly up higher to the deck, there is no isulation and I am wondering about whether or not to tack them in in these places or glass them in ...or ???.

Anyone been in this situation or seen a good solution?

Appreciate any advice. Happy holidays,

Mikey
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top