SailNet Community banner

Should I unfasten PSS collar and redo the alignment?

  • yes, redo right away.

    Votes: 3 100.0%
  • get the engine running again and revisit after a few short cruises

    Votes: 0 0.0%
  • seems like the alignment is fine, congratulations

    Votes: 0 0.0%
1 - 2 of 2 Posts

·
Super Moderator
Joined
·
4,062 Posts
I'm trying to picture this. 3.5 mm is not that big of a drop, but I wonder if it was enough to sufficiently change the
angle through the shaft log, and apply unequal pressure through to the cutlass bearing? Sounds like you should try aligning the shaft.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top