SailNet Community banner
1 - 1 of 1 Posts

·
Registered
Joined
·
35 Posts
BELLATRIX1965,

I had the same issue with our boat. You can order various sizes of aluminum threaded rod from McMaster Carr. I put some locktite on the threads, screwed it in about 1/4" then cut of the rod. A bit of sanding and some paint, and you'll never know the holes were there. Just don't allow too much of the rod to stick out on the inside of the mast, or you might create a snag for your halyards.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top