SailNet Community banner
1 - 2 of 2 Posts

·
Registered
Joined
·
55 Posts
I am just completing my bimini for my B331. I made a mock up frame using duct tape and light lumber. Once I determined the dimensions I had the stainless tubes bent and ordered fittings. I positioned the mid support just ahead of the double backstays. Once the steel was ready I fitted it on the boat and again used duct tape to simulate the canvas and location of back stay openings.I then delivered the assembled frame to the canvas shop. I expect to install the unit this weekend.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top