SailNet Community banner
1 - 1 of 1 Posts

· Barquito
Joined
·
3,924 Posts
Reaction score
1,110
To add to SeaChanger's question: If using a tungsten/carbide scraper, is it a good idea to dress the edges a bit so they don't leave gouges? I think scraping is the way to go, too. However, on my boat the shape of the bottom makes it difficult to avoid the gouges.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top