SailNet Community banner
1 - 1 of 1 Posts

·
Learning the HARD way...
Joined
·
7,823 Posts
This is actually a very simple extrusion. The problem with extrusions is they are so cheap to design that anybody that can justify 1000 lbs of it will have the die cut and pass the cost off to the customer. A die like that is about $1500. The cost of aluminum is about $2/lb. So a part like that is about $10 of aluminum and $3 in finish. Add $5 for drilling and cutting. But you'll pay $125/pair if you can find them. Go figure.

I literally work every day with aluminum extrusions. I am an architectural designer. If you really need these, I can show you how to fabricate some pretty nice replacements for short money. PM if need be.

Don
Why not post here and show us all?:confused:

We'll give you REP Points if you do!:)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top