SailNet Community banner
1 - 1 of 1 Posts

· Registered
1 Posts
Reaction score
Discussion Starter · #1 ·
I purchased an Airmar DST800v direct from Airmar because I wanted the bronze through hull and not the plastic one that comes with the Garmin version of the device. However, instead of a connector, the end of the very long wire harness has a bunch of wires and no connector. This may sound like a silly question but how is it supposed to attach to the Garmin? Can I buy the right connector and where can I find a diagram that shows which wire is supposed to go to what pin? The 740s came with a wiring harness with a bunch of wires as well but there is an actual plug that has a tag on it that says "transducer".
Again, forgive me if this sounds like a silly question. I assume that this is all NEMA2000 stuff? The picture on the box shows a bunch of fancy plugs connecting all devices.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.