SailNet Community banner
1 - 2 of 2 Posts

·
Read Only
Joined
·
87,689 Posts
Reaction score
823
Discussion Starter · #1 ·
By boat, an Elite 32 1983, had an altercation with the dock. I am looking for three tapered stantion poles and one base. These are not the simple straight 1", but taper to a decreased diameter on the upper two-thirds of the pole. Since the boat was made in France, and they no longer market in the US, does anyone know where I might find replacements.
 

·
Super Moderator
Farr 11.6 (Farr 38)
Joined
·
10,824 Posts
Reaction score
5,199
I beleive that most of the deck hardware on the Elite was made by Goiot. They manufactured a toerail/stanchion base/tapered stanchion system that was widely used on French boats. They can be found at:

http://www.goiot.com/us/innovations/generalites.html

They also made a lot of the gear used by Beneteau.So you might try Benteau''s parts dept as wll.

Jeff
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top