SailNet Community banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I removed the deck receiver plate on my P30 to modify the conduit. The receiver plate (MM7845M-2DPR) mates with the domed mast step plug, MM7845M-2DP. I noticed a slight angle to the teardrop dish in the receiver plate, after the fact. It's approximately 2 degrees. How should it be oriented on re-install, high side fore or aft? I measured the parts and have an idea how it should go, but I want to be sure.
 

·
Chastened
Joined
·
4,862 Posts
Yikes, good question. As a P30 owner, I'm familiar with the parts that you have described, but I cannot answer your question. I'm sending you a PM.
 
1 - 2 of 2 Posts
Top