SailNet Community banner
1 - 1 of 1 Posts

· Old Fart
Joined
·
514 Posts
Reaction score
16
The vented loop for the head should go between the pumps outlet and the back of the toilet bowl. Do not install it on the suction/inlet side of the pump as this will cause the system to just suck air in through the vented loop. Most heads come with a short pre-made hose that goes from the pumps outlet around the back of the bowl to inject water into the bowl for flushing. Remove this hose and insert a vented loop in its place..
The vented loop should be above the water line or it will not vent as designed.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top