SailNet Community banner
1 - 2 of 2 Posts

· Registered
Joined
·
10 Posts
Reaction score
0
Discussion Starter · #1 · (Edited)
I am switching out my wood mast for an aluminum one and will be fabricating a mast step, does anyone have any insight on how tight the step should fit into the base of the mast? Also any other information regarding fabricating a mast step would be greatly appreciated.

Thanks.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top