SailNet Community banner
1 - 3 of 3 Posts

·
Registered
Joined
·
634 Posts
Reaction score
125
Discussion Starter · #1 ·
Probably already well known but thought I would share. I had about 10 1" brass screws to remove. All were square drive, 48 years old and stripped round. I took a small star drive and a drill bit slightly smaller than the drive. Each see was drilled to 1/4" depth and star drive hammered in. They all spun right out with cordless... I now fear no screw!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top