SailNet Community banner
1 - 1 of 1 Posts

· Registered
Joined
·
33 Posts
Reaction score
1
Discussion Starter · #1 ·
I've got what looks like stress cracks in the hull around the base of the prop strut. From the inside of the hull things are dry. There are some very slight cracks around some of the periphery of the mount, but the strut itself is not loose and doesn't have any play in it. Cutlass bearing is good, no significant play.

Inside view:


Side view, outside:


Rear view, outside:


No binding on the prop shaft, which leads me to believe there's no significant misalignment.

1) Cause(s)?
2) Solution(s)?

From the outside it certainly looks like it's seen some "bodywork" before. I'm figuring that I need to dig out all around that crack, clean it out, check it out and then refill it with...?

Suggestions welcome and needed!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top