SailNet Community banner

1 - 2 of 2 Posts

·
Registered
Joined
·
994 Posts
Discussion Starter · #1 ·
I am replacing the hoses to my holding tank and want to remove the fittings (plastic 1 1/2 inch)to clean sludge from tank bottom.
How should the threaded and slip over ends of the fitting be sealed I was cosidering 3M 4200 product.any sugestions?
Dave
 

·
Registered
Joined
·
994 Posts
Discussion Starter · #2 ·
I used Teflon tape when I replaced my tank. Check it out at this web site.
http://www.allmandsail.com/holding_tank.htm
 
1 - 2 of 2 Posts
Top