SailNet Community banner
1 - 1 of 1 Posts

· Registered
Joined
·
121 Posts
Reaction score
15
We have a 1999 Beneteau 352 with inmast furler and we haven't had any problems the past two years. I use the topping lift to keep the boom just slightly above level as suggested. Unfurling is usually done heading into the wind and has never been a problem. We take the car out to the black tape mark on the boom. When furling, it is usually best on our boat to have the wind coming over the starboard beam because it helps angle the sail into the furler. It is basically the same as a jib furler, only inside the mast. Keep the bearings lubed on the outhaul car.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top