SailNet Community banner

1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I have a WM hypalon inflatable with an aluminum floor, which was purchased in 2010. The, dark grey, logo on the side became sticky last year and this past summer became downright gooey. The problem is: if you touch it, your fingers get sticky and it's hard to get off. The bigger problem is that it rubs off on other boats, tied up beside it. I noticed I am not the only person with this problem. Several other inflatables tied up at the same dinghy dock also have the problem.
My solution was to remove the logos from both sides of the inflatable. There is now a residue of some adhesive but at least the problem is gone. I wonder if anyone else has had this issue.
 
1 - 1 of 1 Posts
Top