SailNet Community banner
1 - 1 of 1 Posts

· Registered
Joined
·
712 Posts
Reaction score
171
Hey Jim,

I just read your blog. I have to do virtually the same thing next week, except I'm replacing the dripless shaft seal (instead of your traditional stuffin). So after your discovery of the woodruff key and a non-tapered shaft, could you have done it without cutting? My coupler is a solid rust looking thing and now I'm getting nervous. What is meant by "fit and faced", and if my shaft does come off (cross everything :eek:) Other than cleaning it up, do you see anything else i would have to do on re-assembly?

Dave
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top