SailNet Community banner
1 - 1 of 1 Posts

· Registered
137 Posts
Reaction score
Discussion Starter · #1 ·
Hi all;

We will be starting the install of our Icebox refrigeration this weekend. The unit I purchased is an Isotherm 4203, which is an Seawater cooled, ASU unit with holding plate. I will be installing the plate above the shelf in our small icebox. The box is ~3.5 cuft, and the shelf will make a ~1cuft freezer with spillover.

The seacocks are already in place from a previous watermaker install. The compressor will be located behind the gallery bulkhead in the lazarette.

Any works of advice or encouragement? How small of a radius can I bend the 6mm tubing of the kit?

Thanks in advance,
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.