SailNet Community banner
1 - 1 of 1 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
Does anyone have a successful way of leaching old impregnated salt from plywood. I have a small area near the bilge on a fore peak bin plywood bulkhead bin that in the past has taken on salt water. Now if I clean it up and varnish in a few months the salt breaks out again.
Currently it is a small area that can be controlled if I could leach the salt out. Any ideas would be very welcome. Vinegar has been suggested as an option.
 
1 - 1 of 1 Posts
Top