SailNet Community banner
1 - 1 of 1 Posts

·
.
Joined
·
1,000 Posts
There are three types of hinge adjustments on the Lewmars.

one is as explained above, a hex screw at the end of each hinge, there was an older model that had hex screws on the side, and the third, used in the latches, is a small hole, that looks like a hex screw, but this one is on the side of a round face nut.

You need to pull the cover off, to expose this nut, then use a sharp object or a thin scre driver to rotate the nut, wich will increase hinge friction.

The latches are the third type above

Hope it helps

Alex
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top